Alpine A110 II
Car parts and drivetrain components for Alpine A110 II.
Products for Alpine A110 II
- Position: Rear left
- Total length: 640 mm
- Splines gearbox side: 27
- Splines wheel side: 29
- Total length: 631 mm
- Splines gearbox side: 27
- Splines wheel side: 29
- ABS teeth: 0
Frequently Asked Questions about Alpine A110 II Drivetrain
How do I know if the drive shaft on my Alpine A110 II needs replacing?
The most common signs are vibrations under acceleration or clicking noises when cornering. You should also check whether the CV boots are split or if there are grease splatters inside the wheels.
Can I replace just the CV boot instead of the entire drive shaft?
Yes, if the damage is caught early and the CV joint is still clean and well lubricated, replacing just the boot may be enough. If the joint has started to make knocking noises, the entire driveshaft or CV joint must be replaced.
Is there a difference between the right and left drive shafts on the A110 II?
Yes, on the Alpine A110 II the drive shafts are often different lengths due to the position of the gearbox. Always check the exact specification for the driver's side or passenger's side.
How does a worn or damaged drive shaft affect the car's performance?
A worn drive shaft can cause imbalance, severe vibrations and, in the worst case, complete failure where drive is no longer transferred to the wheels, posing a serious safety risk.
Do these parts fit all versions of the Alpine A110 II?
Our parts are matched to the A110 II range, but we always recommend selecting your vehicle by make, model and engine variant to ensure the exact fit for your car.
How quickly can I have my spare parts delivered?
We aim to dispatch all in-stock parts for your Alpine A110 II swiftly across the EU, so you can get your car back on the road without delay.