BMW 2 Serie 220 I F23

Spare parts and drivetrain components for BMW 2 Serie 220 I F23. Check fitment by selecting your make, model and engine before ordering.

Products for BMW 2 Serie 220 I F23

21 products
1 - 21 of 21
Item no.:4160993
  • Position: Rear left
  • Splines gearbox side: 27
  • Splines wheel side: 28
  • Total length: 739 mm
  • Joint diameter: 90 mm
Item no.:5140738
  • Position: Rear right
  • Splines gearbox side: 27
  • Splines wheel side: 28
  • Total length: 805 mm
  • Joint diameter: 77 mm
Item no.:7316104
  • Position: Rear
  • Splines gearbox side: 27
  • Splines wheel side: 28
  • Total length: 750 mm
Item no.:7316103
  • Position: Rear
  • Splines gearbox side: 27
  • Splines wheel side: 28
  • Total length: 748 mm
  • Joint diameter: 77 mm
Item no.:5114726
  • Position: Rear right
  • Splines gearbox side: 27
  • Splines wheel side: 28
  • Total length: 793 mm
  • Joint diameter: 90 mm
Item no.:647918
  • Position: Rear, Inner
  • Inner splines: 30
  • Splines gearbox side: 27
  • Total length: 175 mm
Item no.:453879
  • Position: Rear, Outer
  • Inner splines: 28
  • Splines wheel side: 30
  • Total length: 133 mm
Item no.:458534
  • Position: Rear, Outer
  • Splines wheel side: 28
  • Seal diameter: 57 mm
  • Outer splines: 28
  • Splines gearbox side: 25
Item no.:6506270
  • Position: Outer
  • Inner splines: 25
  • Splines wheel side: 28
  • Outer diameter: 90 mm
Item no.:513329
  • Position: Rear right
  • Splines gearbox side: 27
  • Splines wheel side: 28
  • Total length: 802 mm
Item no.:642392
  • Position: Rear, Inner
  • Inner splines: 30
  • Seal diameter: 43,9 mm
  • Total length: 101 mm
  • Outer splines: 27
Item no.:659569
  • Position: Rear, Outer
  • Inner splines: 30
  • Seal diameter: 57 mm
  • Outer splines: 28
  • Thread size: M24X1,5
Item no.:359641
  • Position: Front, Outer
  • Inner splines: 33
  • Seal diameter: 56 mm
  • Outer splines: 31
  • ABS teeth: 31
Item no.:646193
  • Position: Rear, Inner
  • Inner splines: 25
  • Splines gearbox side: 25
  • Seal diameter: 57,4 mm
  • Total length: 133 mm
Item no.:0689103
  • Total length: 97 mm
Item no.:0935615
  • Inner diameter: 43 mm
  • Outer diameter: 90 mm
Item no.:0699610
  • Total length: 98 mm
Item no.:694092
  • Position: Rear
Item no.:690831
  • Position: Rear
Item no.:698867
  • Position: Rear

Drivetrain for BMW 2 Serie 220 I F23

The BMW 2 Serie 220 I F23 is a car that blends sporting performance with the open-air freedom only a convertible can deliver. To keep this driving experience intact, your drivetrain must remain in peak condition. Power transmission in a BMW is a sophisticated process where every component must interact with millimetre precision. As driveline specialists, we understand the exacting demands placed on the 220 I F23 model. With 5 tailored products in our range for this specific variant, we provide solutions that match or exceed original equipment specifications. Maintaining the drivetrain is not merely a matter of reliability; it preserves the precise balance and sharp throttle response BMW drivers expect. Choosing the correct replacement parts ensures that engine torque reaches the road smoothly, without power loss or intrusive vibrations.

How the drivetrain is engineered on the BMW 2 Serie 220 I F23

The drivetrain layout on the BMW 2 Serie 220 I F23 follows the marque's traditional rear-wheel-drive architecture. Power originates in the longitudinally mounted engine and travels through the gearbox into a central propeller shaft. This prop shaft delivers torque rearward to the differential, which then distributes power to the rear wheels via two drive shafts. Such a configuration demands exceptional propeller shaft balancing and driveshafts capable of managing continuous angular changes and suspension travel. Because the F23 is a convertible, the chassis and drivetrain are tuned to cope with the distinctive torsional dynamics of an open-top body. Every element, from the inner CV joints to the prop shaft centre bearing, plays a critical part in curbing cabin noise and ensuring maximum ride refinement. A sound drivetrain lies at the very heart of the car's driving dynamics.

Common faults and symptoms

When driveline components on a BMW 2 Serie 220 I F23 begin to wear out, they generally produce unmistakable symptoms. One of the most frequent indicators of a failing drive shaft on the BMW 2 Serie 220 I F23 is a rhythmic clicking noise during tight manoeuvres or under hard acceleration from a standstill. If you feel vibrations through the centre console or underneath the seats at specific speeds, this often points to an unbalanced propeller shaft or a deteriorated centre bearing. It is equally important to inspect the differential and gearbox for oil leaks, which can signal worn shaft seals. Because the 220i engine delivers smooth, linear torque, even slight play in the CV joints can manifest as driveline snatch or jerking when applying the throttle. Ignoring these warning signs risks secondary damage to costlier assemblies, making prompt diagnosis essential to preserve your car's mechanical health.

Common parts to replace on the BMW 2 Serie 220 I F23

Within the drivetrain range for the BMW 2 Serie 220 I F23, specific components endure more stress and wear than others. The drive shafts are constantly exposed to road debris, road grit and heavy mechanical loads, which can cause CV boots to split and lose their lubricating grease. We supply high-grade replacements whenever you require a complete drive shaft for the BMW 2 Serie 220 I F23. Another vital assembly is the propeller shaft, and we stock dedicated options for the propeller shaft on the BMW 2 Serie 220 I F23 to eliminate driveline shudder and restore seamless power delivery. Alongside these primary components, related parts such as flexible guibo discs and centre bearings often require attention, as they act as essential dampers. Replacing fatigued components with precision-engineered new units restores the original driving feel and protects the differential from unnecessary stress.

Finding the right part for your BMW 2 Serie 220 I F23

Select the relevant category for your BMW 2 Serie 220 I F23 below:

When dealing with driveline issues, selecting the correct subcategory straight away saves valuable time. By comparing the specific sections for the BMW 2 Serie 220 I F23, you can easily distinguish between problems with a drive shaft, CV joint or propeller shaft, taking you directly to the parts that match your symptoms and exact vehicle fitment.

Why choose CVJoint24?

CVJoint24 is the international shop of a Swedish driveline specialist, operating from our central warehouse in Helsingborg, Sweden, and shipping across the EU. We have built our business on in-depth technical expertise and a carefully curated range centred on quality and accurate fitment. When sourcing parts for your BMW 2 Serie 220 I F23 from us, you receive high-grade car parts backed by our dependable fitment guarantee. We value your time, dispatching stocked items swiftly across Europe so that you can get your convertible back on the road without delay. Our goal is to ensure you select the correct part first time, avoiding frustrating returns and compatibility doubts. Combining technical know-how with attentive customer support and fair prices, we are the trusted choice for both dedicated enthusiasts and professional garages who insist on quality for their BMW.

Frequently Asked Questions about Drivetrain Parts for BMW 2 Series 220 i F23

How do I know if the drive shaft on my BMW 220i F23 is faulty?

The most common signs are clicking noises when turning, vibrations under acceleration, or visible grease leaking from the drive shaft boots.

Do all propeller shafts fit the BMW 2 Series?

No, propeller shafts vary depending on the engine variant, gearbox and wheelbase. Always filter by make, model and engine to find the correct prop shaft for your 220 i F23.

Why does my BMW 2 Series 220 i F23 vibrate during acceleration?

Vibrations under acceleration are often caused by an imbalanced propeller shaft, a worn centre bearing, or play developing in the inner CV joints.

Can I replace just the CV joint or do I need to replace the entire drive shaft?

On many BMW models the drive shaft is a single assembly, but in some instances individual CV joints can be replaced. We often recommend a complete drive shaft for optimal durability and simpler installation.

How does your fitment guarantee work for BMW parts?

Our fitment guarantee means that when you select your vehicle's make, model and engine variant, we guarantee the part will fit your specific BMW 2 Series 220 i F23.

How quickly are parts for the BMW 2 Series 220 i F23 delivered?

We offer fast delivery on most stocked components, ensuring your order is dispatched swiftly from our warehouse.