BMW 2000
Car parts and drivetrain components for BMW 2000.
Products for BMW 2000
- Position: Inner
- ABS teeth: 0
- Inner splines: 28
- Joint diameter: 108 mm
- Outer diameter: 108 mm
- Position: Rear, Outer
- Inner splines: 24
- Outer diameter: 100 mm
Frequently asked questions about BMW 2000 drivetrain components
How do I know if my BMW 2000 needs a new drive shaft?
The most common signs are vibrations under acceleration or clicking noises when turning. If you notice an imbalance while driving, inspect the drive shafts immediately.
What is the purpose of the centre bearing on a BMW 2000?
The centre bearing keeps the propeller shaft properly aligned and reduces vibrations in the drivetrain. A worn bearing can cause severe shaking through the bodywork.
Can I replace just the CV joint, or do I need to replace the entire drive shaft?
It is possible to replace only the joint, but on classic cars such as the BMW 2000, it is often more cost-effective and dependable to replace the complete drive shaft assembly.
Why is there a clicking noise when turning in my BMW 2000?
A clicking noise on full lock usually indicates a worn outer CV joint, frequently caused by a split or torn CV boot.
Do all propeller shafts fit every BMW 2000 model?
No, dimensions can vary depending on the model year and gearbox type. Always select your exact make, model and engine variant in our vehicle selector to ensure you get the correct part.
What happens if a CV boot splits?
When a CV boot splits, grease escapes and road dirt enters the joint, leading to rapid wear and premature constant velocity joint failure.