BMW 3 Serie 318 I E46
Car parts and drivetrain components for BMW 3 Serie 318 I E46. Always check the fit before ordering.
Products for BMW 3 Serie 318 I E46
- Position: Rear right
- Flange diameter: 100 mm
- Total length: 668 mm
- Splines wheel side: 27
- ABS teeth: 48
- Position: Rear left, Rear right
- Flange diameter: 94 mm
- Total length: 625 mm
- Splines wheel side: 27
- ABS teeth: 48
- Position: Rear right
- Flange diameter: 94 mm
- Total length: 675 mm
- Splines wheel side: 27
- ABS teeth: 48
- Diameter: 30 mm
- Hole spacing c/c: 160 mm
- Bearing thickness: 35 mm
- Diameter: 25 mm
- Hole spacing c/c: 160 mm
- Bearing thickness: 29 mm
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,401 mm
- Position: Rear, Outer
- Inner splines: 24
- Outer diameter: 86 mm
- Splines wheel side: 27
- ABS teeth: 48
- Flange diameter: 94 mm
- Total length: 675 mm
- Splines wheel side: 27
Frequently Asked Questions about Drivetrain Parts for BMW 3 Series 318i E46
What are the most common signs of a failing propeller shaft on my E46 318i?
The most common symptoms are vibrations throughout the car under acceleration or at speeds around 80–100 km/h. You may also hear a thumping noise from underneath the centre console if the centre bearing or giubo (propshaft coupling) is worn.
Do all drive shafts from the E46 range fit my 318i?
No, drive shafts vary depending on engine size, gearbox type (manual or automatic) and model year. Always select your BMW 318i E46 by make, model and engine to find the exact drive shaft for your car.
Why is the ABS warning light on in my BMW 3 Series 318i E46?
A very common cause on the E46 is that the ABS ring on the rear axle has corroded, swollen or cracked. This prevents the sensor from reading the wheel speed correctly, triggering the warning light.
Is it difficult to replace an ABS ring yourself on an E46?
It requires removing the drive shaft from the wheel hub. Once the shaft is free, the old ring can be tapped off and the new one pressed or heat-shrunk into place. It is a common job for a competent DIY mechanic.
How often should I inspect the drive shaft boots?
We recommend inspecting the CV boots at every service or wheel change. A split boot quickly leads to CV joint failure due to dirt ingress and grease loss.
Do you offer a fitment guarantee on BMW drivetrain parts?
Yes, we offer a fitment guarantee when you choose your vehicle by make, model and engine. This ensures that the part is technically correct for your specific BMW 3 Series 318i E46.