BMW X4 Xdrive 20 D F26
Car parts and drivetrain components for BMW X4 Xdrive 20 D F26. Always check the fit before ordering.
Products for BMW X4 Xdrive 20 D F26
- Position: Front left
- Total length: 592 mm
- Splines gearbox side: 27
- Splines wheel side: 37
- Position: Front right
- Total length: 881 mm
- Splines gearbox side: 27
- Splines wheel side: 37
- Position: Front right
- Total length: 825 mm
- Splines gearbox side: 27
- Splines wheel side: 30
- Position: Rear left
- Total length: 769 mm
- Splines gearbox side: 27
- Splines wheel side: 30
- Position: Outer
- Seal diameter: 65 mm
- Inner splines: 33
- Outer splines: 37
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,280 mm
- Position: Front right, Inner
- Inner splines: 24
- Diameter: 65 mm
- Total length: 462 mm
- Splines gearbox side: 27
- Position: Rear, Outer
- Total length: 135 mm
- Splines gearbox side: 30
- Splines wheel side: 25
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,280 mm
- Diameter: 30 mm
- Height: 54 mm
- Hole spacing c/c: 160 mm
- Bearing thickness: 36 mm
- Position: Rear left
- Total length: 772 mm
- Splines gearbox side: 27
- Splines wheel side: 30
- ABS teeth: 0
- Position: Rear right
- Total length: 829 mm
- Splines gearbox side: 27
- Splines wheel side: 30
- ABS teeth: 0
- Position: Front right
- Total length: 499 mm
- Splines gearbox side: 34
- Splines wheel side: 31
- Total length: 824 mm
- Splines gearbox side: 27
- Splines wheel side: 30
- Position: Outer
- Seal diameter: 65 mm
- Inner splines: 33
- Outer splines: 37
- Joint diameter: 86 mm
- Position: Front left, Inner
- Total length: 170 mm
- Splines gearbox side: 27
- Splines wheel side: 24
- ABS teeth: 24
- Position: Front, Outer
- Seal diameter: 65 mm
- Inner splines: 33
- Splines wheel side: 37
Frequently Asked Questions about Drivetrain for BMW X4 Xdrive 20 D F26
How do I know whether it is the drive shaft or propeller shaft vibrating on my BMW X4?
Vibrations from a drive shaft are usually felt most under acceleration and can vary depending on the steering angle. Vibrations from a propeller shaft are typically speed-dependent and felt through the vehicle body regardless of whether you are turning or driving straight.
Does the same CV joint fit all BMW X4 F26 models?
No, there can be differences depending on engine variants and drivetrain systems. For the Xdrive 20 D F26, it is vital to check spline counts and dimensions. Always select your vehicle's exact make, model and engine to ensure the correct fitment.
What are the most common signs of a worn outer CV joint?
The classic symptom is a rhythmic clicking noise when driving in circles or making sharp turns. If the noise disappears when driving straight, the outer CV joint is almost certainly the culprit.
Can I replace just the CV boot if the CV joint is still in good condition?
Yes, if you discover a split CV boot early before dirt has entered and damaged the joint, replacing the boot and repacking it with fresh grease is often sufficient. However, if the joint has already started making noises, it must be replaced.
Why is the xDrive system sensitive to drivetrain faults?
The xDrive system distributes power electronically based on mechanical feedback. If a drive shaft or prop shaft has play or imbalance, it can disrupt system sensors and, in the worst case, cause excessive wear to the transfer box.
Do you offer a fitment guarantee on parts for BMW X4 Xdrive 20 D F26?
Yes, when you choose your vehicle's exact make, model and engine and buy the parts recommended for your specific vehicle, you are covered by our fitment guarantee for complete peace of mind.