BMW X5 Xdrive 50 I E70

Drivetrain components and spare parts for the BMW X5 Xdrive 50 I E70. Select your make, model and engine to ensure a correct fit before ordering.

Products for BMW X5 Xdrive 50 I E70

38 products
1 - 24 of 38
Item no.:1148948
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 637 mm
  • Joint diameter: 86 mm
Item no.:2196942
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,019 mm
  • Joint diameter: 86 mm
Item no.:6158796
  • Position: Rear
  • Splines gearbox side: 32
  • Splines wheel side: 30
  • Total length: 809 mm
  • Joint diameter: 96 mm
Item no.:0239610
  • Position: Front
  • Total length: 707 mm
  • Number of joints: 2
  • Outer diameter 2: 47 mm
  • Bolt circle diameter 2: 77 mm
Item no.:0202208
  • Position: Rear
  • Total length: 1,400 mm
  • Number of joints: 2
  • Outer diameter 1: 14 mm
  • Bolt circle diameter 1: 96 mm
Item no.:247000
  • Position: Inner
  • Total length: 568 mm
  • Outer splines: 27
Item no.:146912
  • Position: Inner
  • Outer splines: 27
Item no.:658650
  • Position: Rear, Outer
  • Inner splines: 25
  • Splines wheel side: 30
Item no.:327460
  • Position: Front
Item no.:326452
  • Position: Front
Item no.:399389
  • Total length: 56 mm
  • Diameter: 24 mm
Item no.:0837965
  • Inner diameter: 30 mm
  • Bearing thickness: 36 mm
  • Hole spacing c/c: 160 mm
  • Height: 54 mm
Item no.:0113004
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 642 mm
Item no.:3585037
  • Position: Outer
  • Inner splines: 33
  • Seal diameter: 65 mm
  • Outer splines: 30
  • Thread size: M27X1,5
Item no.:358876
  • Position: Front, Outer
  • Inner splines: 33
  • Seal diameter: 65 mm
  • Outer splines: 30
  • Thread size: M27X1,5
Item no.:0690572
  • Total length: 108 mm
  • Inner diameter: 22 mm
  • Outer diameter: 80 mm
  • Height: 85 mm
Item no.:0533038
  • Position: Outer
  • Inner splines: 28
  • Splines wheel side: 30
  • Outer diameter: 96 mm
Item no.:0454998
  • Position: Inner
  • Inner splines: 28
  • Outer diameter: 96 mm
  • Splines wheel side: 32
Item no.:2167300
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,020 mm
  • Joint diameter: 86 mm
Item no.:1143827
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 634 mm
  • Joint diameter: 86 mm
Item no.:242506
  • Position: Front right, Inner
  • Inner splines: 26
  • Seal diameter: 29,97 mm
  • Total length: 569 mm
  • Outer splines: 27
Item no.:141823
  • Position: Front left, Inner
  • Inner splines: 26
  • Seal diameter: 43,9 mm
  • Total length: 183 mm
  • Outer splines: 27
Item no.:3537059
  • Position: Front, Outer
  • Inner splines: 33
  • Seal diameter: 65 mm
  • Outer splines: 30
  • Thread size: M27X1,5
Showing 1–24 of 38 products

Drivetrain for BMW X5 Xdrive 50 I E70

The BMW X5 Xdrive 50 I E70 is a vehicle that blends luxury with exceptional performance, and its drivetrain is the beating heart of this driving experience. As an owner of an X5 with the potent V8 engine, you know that every component in the power transmission is subjected to severe stresses, especially under hard acceleration, when driving in demanding conditions, or when carrying heavy loads. At CVJoint24, you will find the specific parts required to service and repair your BMW X5 so that it continues to deliver the handling and stability you expect. We focus exclusively on drivetrain components, allowing us to offer technical expertise and depth of range that general car parts retailers often lack.

Maintaining the drivetrain on a high-performance vehicle like the E70 is essential for both safety and reliability. A minor imbalance or early signs of wear can quickly escalate into extensive damage to costly components such as the gearbox or differentials. By choosing the right spare parts from a dedicated specialist, you ensure that your BMW retains its original dynamics. We understand the technical nuances of BMW engineering and only offer parts that meet or exceed the requirements needed to handle the impressive power output of the 50i model.

How the drivetrain is designed on the BMW X5 Xdrive 50 I E70

The drivetrain of a BMW X5 Xdrive 50 I E70 is an engineering masterpiece centred around the xDrive system, BMW's intelligent all-wheel-drive platform. The system continuously distributes power between the front and rear axles depending on road conditions and driving dynamics to maximise traction. Power travels from the engine through the gearbox to a transfer box, which then channels torque via propeller shafts to both the front and rear differentials. From the differentials, drive is finally delivered to the wheels via drive shafts. On an E70 model such as the Xdrive 50 I, these components are engineered to withstand considerable forces, yet they remain complex assemblies that are vulnerable to wear in their joints and bearings.

Precision throughout every link of this system is paramount. An incorrect angle in a CV joint or an unbalanced prop shaft can rapidly create vibrations that resonate through the entire chassis. This not only impairs ride comfort, but can also cause premature wear to the transfer box bearings. Because the xDrive system relies on precise wheel-speed data, every mechanical part of the drivetrain must operate flawlessly for the electronic management to function as intended. We supply components calibrated specifically to integrate with this advanced architecture.

Common faults and symptoms

When the drivetrain on a BMW X5 Xdrive 50 I E70 begins to deteriorate, it typically reveals itself through distinct symptoms that every driver should watch for. One of the most frequent signs of an issue with a BMW X5 Xdrive 50 I E70 drive shaft is a clicking or knocking noise when making sharp turns at low speeds, which usually points to a worn outer CV joint. Vibrations felt throughout the cabin or through the seat during acceleration can instead indicate a failing inner constant velocity joint or an unbalanced propeller shaft. On this specific E70 model, wear in the propeller shaft centre bearing is also relatively common, producing a whining or thumping noise from beneath the centre of the car.

Another symptom to monitor is hesitation or jerking from the all-wheel-drive system under acceleration or during low-speed manoeuvres. This can often stem from mechanical play in the driveshafts, which disrupts the xDrive system's torque distribution. Split CV boots are equally problematic; once a boot tears, grease escapes and road dirt penetrates, destroying the CV joint in very short order. By diagnosing these symptoms early and replacing worn components promptly, you can prevent breakdowns and avoid extremely costly repairs to major transmission units.

Common parts to replace on the BMW X5 Xdrive 50 I E70

On the BMW X5 Xdrive 50 I E70, it is primarily the components handling direct power transfer that require replacement over time. Our range focuses on the parts most critical for maintaining your vehicle's stability and traction. We currently supply an extensive selection within the following categories for your specific model:

  • Drive shafts: Complete replacement units reinforced to handle the high torque of the V8 engine, available for both front and rear axles.
  • Propeller shafts: Precision-balanced shafts complete with universal joints and centre bearings to eliminate drivetrain vibrations and guarantee smooth power delivery from the transfer box.

By replacing a worn prop shaft or drive shaft in good time, you prevent harmful vibrations from damaging more expensive assemblies. We ensure you receive components with the exact overall length, spline count and flange design for your specific E70 variant. Explore the most relevant categories for your car below:

  • Drive shafts for BMW X5 Xdrive 50 I E70
  • Propeller shafts for BMW X5 Xdrive 50 I E70

Finding the right part for your BMW X5 Xdrive 50 I E70

Navigate directly to the appropriate section for the BMW X5 Xdrive 50 I E70:

On a vehicle where several drivetrain faults can produce overlapping symptoms, starting in the correct category saves valuable time. By comparing the exact component sections for the BMW X5 Xdrive 50 I E70, you can more easily distinguish between faults in a drive shaft, CV joint or propeller shaft, and head straight to the page that matches your car's symptoms and fitment.

Locating the correct spare part for a BMW X5 Xdrive 50 I E70 can be challenging due to mid-cycle technical updates across the production run. Shaft lengths and flange mountings can differ depending on the build month, gearbox variant, and factory equipment options. To ensure you receive a part that fits faultlessly, always filter by your car's exact make, model and engine variant in our catalogue for BMW.

We also advise checking physical dimensions or original equipment (OEM) reference numbers whenever possible, especially for propeller shafts where several versions may exist for the same model year. Our customer support and detailed technical specifications are designed to give you complete confidence in your purchase. The objective is to get the correct part first time, avoiding costly returns and unnecessary workshop downtime. We have done the technical groundwork matching every part to the correct chassis specifications, making your purchase straightforward.

Why choose CVJoint24

CVJoint24 is not merely another general motor factor; we are a dedicated Swedish driveline specialist shipping across the EU from our central warehouse in Helsingborg, Sweden. When you buy components for your BMW X5 Xdrive 50 I E70 from us, you benefit from focused expertise and proven quality. We understand the engineering demands placed on a high-performance SUV and select our products from manufacturers adhering to rigorous production standards. With our precise fitment assurance, you can rest assured that your new parts will integrate seamlessly with your vehicle's mechanical layout.

We know that vehicle downtime is costly and frustrating. That is why we offer rapid dispatch and dependable delivery across the EU on our stocked range, making us a trusted partner for DIY mechanics and professional garages alike. By focusing on a specialised, deep catalogue within drivetrain components, we deliver competitive pricing alongside technical competence that general car parts sellers cannot match. Trust CVJoint24 for your BMW's drivetrain requirements, where quality, speed and expertise come first.

Frequently Asked Questions about Drivetrain for BMW X5 Xdrive 50 I E70

What are the most common signs of a failing drive shaft on my BMW X5 E70?

The most common symptoms are clicking noises when cornering sharply, which indicates a worn outer CV joint, as well as vibrations under acceleration that often stem from wear in the inner joint.

Does the same propeller shaft fit all BMW X5 E70 models?

No, propeller shafts differ depending on the engine type, gearbox and model year. It is therefore vital to select your exact make, model and engine to find the correct shaft for your Xdrive 50 I.

How does the fitment guarantee work at CVJoint24?

Our fitment guarantee means that if you use our vehicle selector to choose your exact make, model and engine, and order the recommended part, we guarantee it will fit your car correctly.

Why does my BMW X5 Xdrive 50 I vibrate under acceleration?

Vibrations during acceleration are frequently caused by an unbalanced propeller shaft, a worn centre bearing, or play in the drive shaft inner CV joints, which are placed under high load under throttle.

Can I replace just the CV joint, or do I need to replace the entire drive shaft on my BMW?

It depends on the extent of the damage. In many cases you can replace just the CV joint if the shaft itself is undamaged, but if there is extensive wear or damaged splines, a complete drive shaft provides a safer and more durable long-term repair.

How fast are parts dispatched for my BMW X5?

We aim to dispatch all in-stock parts as swiftly as possible so you can get your car back on the road without delay.