BMW X6 M 50 D E71 E72

Spare parts and drivetrain components for BMW X6 M 50 D E71 E72. Select your make, model and engine to ensure fitment before ordering.

Products for BMW X6 M 50 D E71 E72

32 products
1 - 24 of 32
Item no.:1119594
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 662 mm
  • Joint diameter: 86 mm
Item no.:2179986
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 969 mm
  • Joint diameter: 98 mm
Item no.:0482412
  • Position: Front left, Inner
  • Inner splines: 24
  • Seal diameter: 44 mm
  • Total length: 184 mm
  • Joint diameter: 82 mm
Item no.:0581217
  • Position: Outer
  • Inner splines: 33
  • Seal diameter: 65 mm
  • Outer splines: 30
  • Thread size: M27X1,5
Item no.:0217144
  • Position: Front
  • Total length: 707 mm
  • Number of joints: 2
  • Outer diameter 2: 47 mm
  • Bolt circle diameter 2: 77 mm
Item no.:147429
  • Position: Inner
  • Outer splines: 27
Item no.:240344
  • Position: Front right, Inner
  • Inner splines: 24
  • Splines gearbox side: 27
  • Total length: 495 mm
Item no.:653217
  • Position: Rear, Outer
  • Inner splines: 25
  • Splines wheel side: 30
Item no.:324915
  • Position: Front
Item no.:322612
  • Position: Front
Item no.:1180409
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 637 mm
  • Joint diameter: 86 mm
Item no.:219852
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,019 mm
  • Joint diameter: 86 mm
Item no.:610717
  • Position: Rear
  • Splines wheel side: 30
  • Total length: 630 mm
  • Joint diameter: 94 mm
  • Joint diameter, gearbox side: 100 mm
Item no.:390149
  • Total length: 56 mm
  • Diameter: 24 mm
Item no.:0898036
  • Inner diameter: 30 mm
  • Bearing thickness: 36 mm
  • Hole spacing c/c: 160 mm
  • Height: 54 mm
Item no.:1192728
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 663 mm
  • Joint diameter: 86 mm
Item no.:2174041
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,020 mm
  • Joint diameter: 86 mm
Item no.:1166482
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 634 mm
  • Joint diameter: 86 mm
Item no.:2159073
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 973 mm
  • Joint diameter: 86 mm
Item no.:3554714
  • Position: Front, Outer
  • Inner splines: 33
  • Seal diameter: 65 mm
  • Outer splines: 30
  • Thread size: M27X1,5
Item no.:0633375
  • Position: Rear
  • Total length: 124 mm
Item no.:398954
  • Position: Front
Item no.:395645
  • Diameter: 24 mm
  • Height: 56 mm
Item no.:0996089
  • Inner diameter: 44 mm
  • Outer diameter: 67 mm
Showing 1–24 of 32 products

Drivetrain for BMW X6 M 50 D E71 E72

The BMW X6 M 50 D E71 E72 is a powerful machine that demands top-quality components to manage the massive torque produced by its triple-turbocharged diesel engine. The drivetrain in this model is engineered to deliver power to all four wheels via the xDrive system, placing extreme demands on every single link in the chain. When sourcing spare parts for your BMW X6, it is vital to select parts designed specifically for this level of performance. At CVJoint24, we specialise in supplying the precise parts required to preserve your vehicle's stability and power transfer, whether for daily driving or more demanding conditions.

Maintaining the drivetrain on a high-performance SUV like the BMW X6 is an investment in both safety and longevity. Because the M 50 D variant generates substantial forces under acceleration, components such as drive shafts and CV joints wear faster than on standard models. By selecting the correct parts from the start, you minimise the risk of secondary damage to costlier components such as the transfer box or differentials. Our range covers the most critical components for your E71 or E72, making us your natural partner for repairs or preventative maintenance.

How the drivetrain is engineered on the BMW X6 M 50 D E71 E72

The drivetrain on the BMW X6 M 50 D is an engineering masterpiece combining mechanical strength with advanced electronics. The system is based on a longitudinal engine sending power through an automatic gearbox to a central transfer box. From here, power is distributed via a propeller shaft to both the front and rear axles. Each wheel is then driven by a dedicated drive shaft that must accommodate suspension travel and steering angles while transmitting power without losses or vibrations. This complexity means every part, from the smallest boot to the complete shaft, must adhere to very tight tolerances.

To ensure power reaches the road effectively, both inner and outer CV joints are used. An outer CV joint sits closest to the wheel, allowing steering articulation whilst rotating, whereas the inner joint accommodates the axial movements that occur during suspension travel. On an xDrive model, the balance between front and rear axles is critical; the slightest play or imbalance in a prop shaft can cause vibrations throughout the body shell and potentially damage the gearbox output bearings. Precision-engineered spare parts are therefore essential for your vehicle's handling characteristics.

Common faults and symptoms

There are several distinct signs that a component in your BMW X6 drivetrain is beginning to fail. One of the most common symptoms of a worn outer CV joint is a clicking or knocking noise clearly audible when taking sharp turns at low speeds. If the noise disappears when driving straight ahead, the outer constant velocity joint is almost certainly the cause. For the inner joint, the symptoms differ; wear is typically felt as vibrations throughout the vehicle under acceleration, particularly between 60 and 100 km/h. These vibrations are often felt through the seat or floor rather than the steering wheel.

For the propeller shaft, the most frequent issue is imbalance or worn centre bearings and universal joints. This often presents as a low droning sound or high-frequency vibrations that increase with vehicle speed, regardless of engine revs. If you notice a jolt when applying the throttle or during engine braking, it can also point to play in the drivetrain splines or joints. Ignoring these symptoms can lead to catastrophic failure, which on a BMW X6 M 50 D can result in very costly repairs. Prompt diagnosis and replacing a worn inner CV joint saves both money and trouble in the long run.

Common parts to replace on the BMW X6 M 50 D E71 E72

Based on our experience and data, certain components are subject to higher stress on this specific model. We have tailored our range to cover these needs with utmost precision. Here are the most common categories for your BMW X6:

  • Drive shafts: We stock complete shafts for both front and rear axles. A complete drive shaft is often the most cost-effective choice in cases of extensive wear, as you receive both inner and outer joints pre-assembled.
  • Outer CV joints: Ideal when only the wheel-end section is damaged, often due to a split CV boot.
  • Inner CV joints: Essential for eliminating vibrations under acceleration and maintaining ride comfort.
  • Propeller shafts: We supply balanced prop shafts ready for installation, which is vital for the correct operation of the xDrive system.

By focusing on these core areas, we ensure we have the car parts you actually need. Every component is rigorously checked to satisfy the demands set by BMW for their M-Performance vehicles, providing complete peace of mind with your purchase.

How to find the right part for your BMW X6 M 50 D E71 E72

Navigate directly to the appropriate section for the BMW X6 M 50 D E71 E72:

On a vehicle with several possible drivetrain faults, it is best to start in the correct category straight away. By comparing the specific product groups for the BMW X6 M 50 D E71 E72, it becomes much easier to distinguish between drive shaft, CV joint or propeller shaft issues and proceed to the page that best matches your symptoms and fitment.

Identifying the correct replacement part for a BMW X6 can sometimes be challenging due to variations depending on the exact production month or equipment level. The most reliable way to find the right part first time is to filter by your car's make, model and engine variant. This filters out the components verified specifically for your vehicle. This is particularly crucial for driveshafts, where overall length and spline counts must match precisely for safe installation and operation.

If you are unsure which component is causing the issue, we always recommend a visual inspection. Check whether the CV boots are intact; a split boot quickly allows road dirt to enter while throwing out grease, destroying the joint in short order. Grease splatters on the inside of the wheel rim are a tell-tale sign of a torn boot. Once you have identified what needs replacing, you can rely on our BMW X6 M 50 D E71 E72 listings and our expert technical support to help you select the right drivetrain components.

Why buy from CVJoint24?

CVJoint24 is not just another car parts retailer; we are the international shop of a Swedish driveline specialist with our central warehouse in Helsingborg, Sweden. Our strength lies in our deep niche expertise and dedication to supplying the exact part for your vehicle. When shopping with us, you gain access to a catalogue with exceptional depth that few can match. We understand the technical nuances of the BMW X6 M 50 D and know what is needed for a reliable, long-lasting repair.

We also provide a fitment guarantee, allowing you to order with complete confidence. Combined with our prompt dispatch across the EU, we help minimise the time your car spends off the road in the garage. Choosing us means choosing quality, technical insight and a smooth buying experience. We are passionate about drivetrains and power transfer, and our aim is to give you the best support possible to keep your BMW performing at its peak. Order the right part straight away and experience the difference of a dedicated specialist.

Frequently Asked Questions about Drivetrain Parts for BMW X6 M 50 D E71 E72

What are the most common signs of a failing drive shaft on my BMW X6?

The most common signs are clicking noises when turning (outer joint) or noticeable vibrations during acceleration (inner joint). If you detect imbalance at higher speeds, it could also point to an issue with the propeller shaft.

How do I find the right parts for my car?

Simply select your car's make, model, and engine variant to immediately display the drive shafts, CV joints, and propeller shafts that precisely match your BMW X6 M 50 D E71 E72.

Do you offer a guaranteed fit on drivetrain components?

Absolutely! We provide a fitment guarantee on all our parts, giving you complete peace of mind that the product you order will fit your specific vehicle model perfectly.

What is the difference between an inner and an outer CV joint?

The outer CV joint sits at the wheel hub and accommodates steering angles, whereas the inner joint connects to the gearbox or differential and accommodates suspension movement. They produce distinct symptoms when worn.

How quickly can I receive my parts?

We aim for fast dispatch and swift delivery across Europe to get your BMW X6 back on the road as quickly as possible. We know how crucial quick service is when carrying out repairs.

Why should I choose CVJoint24 instead of a general car parts retailer?

We are Swedish driveline specialists offering unmatched depth in our product range. We have far greater expertise in fitment and technical specifications for power transmission than general auto factors.