BMW X6 Xdrive 35 I E71 E72

Quality spare parts and drivetrain components for the BMW X6 Xdrive 35 I E71 E72. Select your exact vehicle model and engine to verify fitment before ordering.

Products for BMW X6 Xdrive 35 I E71 E72

43 products
1 - 24 of 43
Item no.:6177596
  • Position: Rear
  • Splines wheel side: 30
  • Total length: 630 mm
  • Joint diameter: 94 mm
  • Joint diameter, gearbox side: 100 mm
Item no.:0241628
  • Position: Front
  • Total length: 707 mm
  • Number of joints: 2
  • Outer diameter 2: 47 mm
  • Bolt circle diameter 2: 77 mm
Item no.:0266004
  • Position: Front
  • Total length: 709 mm
  • Outer diameter 1: 10 mm
  • Bolt circle diameter 1: 78 mm
Item no.:0275008
  • Position: Rear
  • Total length: 1,400 mm
  • Number of joints: 2
  • Outer diameter 1: 14 mm
  • Bolt circle diameter 1: 96 mm
Item no.:242866
  • Position: Inner
  • Total length: 568 mm
  • Outer splines: 27
Item no.:149493
  • Position: Inner
  • Outer splines: 27
Item no.:643028
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 44 mm
  • Total length: 148 mm
  • Outer splines: 27
Item no.:657184
  • Position: Rear, Outer
  • Inner splines: 25
  • Splines wheel side: 30
Item no.:457616
  • Position: Rear, Outer
  • Inner splines: 28
  • Splines wheel side: 30
  • Total length: 146 mm
Item no.:0141057
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 642 mm
Item no.:2141199
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,055 mm
Item no.:1191113
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 670 mm
Item no.:1100480
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 637 mm
  • Joint diameter: 86 mm
Item no.:2188052
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,019 mm
  • Joint diameter: 86 mm
Item no.:0893907
  • Inner diameter: 30 mm
  • Bearing thickness: 36 mm
  • Hole spacing c/c: 160 mm
  • Height: 54 mm
Item no.:2189022
  • Position: Front right
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 1,020 mm
  • Joint diameter: 86 mm
Item no.:1170335
  • Position: Front left
  • Splines gearbox side: 27
  • Splines wheel side: 30
  • Total length: 634 mm
  • Joint diameter: 86 mm
Item no.:393881
  • Diameter: 24 mm
  • Height: 56 mm
Item no.:390589
  • Total length: 56 mm
  • Diameter: 24 mm
Item no.:393398
  • Position: Front
Item no.:0651450
  • Total length: 123 mm
Showing 1–24 of 43 products

Drivetrain for BMW X6 Xdrive 35 I E71 E72

The BMW X6 Xdrive 35 I E71 E72 represents a unique blend of power and engineering where the drivetrain plays a decisive role. As one of the first entries into the sports SUV sector, this BMW places exceptionally high demands on its mechanical parts. Its turbocharged straight-six engine delivers substantial torque that must be channelled through the gearbox, transfer box and onwards to the wheels via an intricate network of shafts. Maintaining these components is not merely a matter of mechanical reliability, but also of preserving the distinct handling characteristics delivered by the xDrive system.

When considering the drivetrain for this particular model, it is vital to recognise that the forces involved are far greater than on ordinary road cars. A heavy kerb weight combined with genuine performance pedigree means that wear on drive shafts and propeller shafts can accelerate rapidly, especially during enthusiastic driving or regular travel over varied surfaces. We specialise in supplying components engineered to withstand these stresses, manufactured with the precision needed to keep your vehicle performing at its peak year after year.

How the drivetrain is engineered on the BMW X6 Xdrive 35 I E71 E72

The layout of the drivetrain on a BMW X6 Xdrive 35 I E71 E72 is a masterclass in modern automotive design. The system relies on xDrive, BMW's intelligent all-wheel-drive technology, which continuously varies power delivery between the front and rear axles. A central transfer box directs torque through two separate prop shafts—one running forwards and one towards the rear. For this specific model, we have identified a clear requirement for exacting precision, reflected in our comprehensive range of propeller shafts tailored to match all technical configurations.

Extending outwards to the wheels are the drive shafts. These are responsible for transmitting power from the differentials to the wheel hubs while accommodating steering angles and suspension travel. On an X6 E71, these driveshafts are sized to cope with formidable loads, yet they remain vulnerable to everyday wear and environmental damage. We stock dedicated drive shafts for this model, ensuring we supply the correct part whether you require a front or rear axle component. Every item is engineered to integrate seamlessly with the car's existing chassis setup.

Common faults and symptoms

Spotting drivetrain issues early can save substantial sums in workshop repair bills. One of the most typical signs of a worn propeller shaft in a BMW X6 is a distinct vibration felt through the car body, frequently occurring at specific road speeds or under hard acceleration. These vibrations often stem from shaft unbalance or failing centre bearings and universal joints. Because the X6 cabin is exceptionally well insulated, these tremors can be subtle at first; however, they should never be ignored as they can trigger costly secondary damage to the gearbox and differentials.

With drive shafts, the classic warning sign is a repetitive clicking or knocking noise when turning on full lock, such as when parking or negotiating tight bends. This almost always points to a worn outer CV joint, usually caused by a split CV boot that has allowed water and grit to enter while letting the grease escape. If you notice driveline snatch, hesitation or unusual noises from underneath, a thorough inspection is essential. Prompt diagnosis is key to preserving the high safety standards expected of the BMW X6 E71/E72.

Common parts to replace on the BMW X6 Xdrive 35 I E71 E72

The components most frequently requiring replacement on this model are, without doubt, the drive shafts and propeller shafts. Owing to vehicle mass and engine torque, the front drive shafts in particular are subjected to extreme operating angles and high loads. Fitting a complete replacement drive shaft is often far more cost-effective than rebuilding individual joints, as you benefit from factory-fitted CV boots, fresh grease and guaranteed longevity.

The prop shaft is another critical area. On the X6 E71 platform, the front propeller shaft commonly needs renewing due to wear in its universal joints, which can cause catastrophic driveline damage if left unchecked. We offer reinforced alternatives engineered specifically to handle the demands of the xDrive drivetrain. Choosing parts from our range ensures your BMW maintains its factory refinement and balance, with zero compromise on the quality of rotating driveline components.

How to find the right part for your BMW X6 Xdrive 35 I E71 E72

Navigate directly to the appropriate section for your BMW X6 Xdrive 35 I E71 E72:

On a vehicle with several potential driveline issues, selecting the correct category from the start saves valuable time. By comparing the dedicated part categories for the BMW X6 Xdrive 35 I E71 E72, you can quickly distinguish between symptoms related to drive shafts, CV joints or propeller shafts, guiding you straight to the exact fitment.

Choosing the correct spare parts for a technically intricate vehicle like the BMW X6 demands careful attention. Variations exist in shaft lengths, spline counts and mounting flanges depending on production dates and factory equipment packages. To make selecting parts straightforward and error-free, simply filter our catalogue by your vehicle's exact make, model and engine variant. This ensures that every item displayed is fully verified to fit your BMW X6 Xdrive 35 I E71 E72.

Once your vehicle details are selected, you can jump straight into the relevant product sections to source your parts. Here are the primary product categories for your model:

  • Drive shafts for BMW X6 Xdrive 35 I E71 E72
  • Propeller shafts for BMW X6 Xdrive 35 I E71 E72
Following these links gives you an immediate overview of product options, precise technical specifications and live stock levels, allowing you to order the correct components with complete confidence.

Why shop with CVJoint24?

CVJoint24 is far from a standard car parts retailer; we are a dedicated Swedish driveline specialist focused purely on drivetrain components. Our business combines in-depth technical expertise with a curated product inventory of the highest quality standards. For owners of the BMW X6 Xdrive 35 I E71 E72, this provides direct access to components engineered to meet the vehicle's exacting demands. We appreciate that your car is a substantial investment, requiring replacement parts that are genuinely up to the task.

When ordering from our Swedish warehouse, you benefit from our precise fitment accuracy and knowledgeable support from driveline specialists ready to help DIY mechanics and professional garages alike. With prompt dispatch across Europe, you can make repairs quickly and return to the road with total confidence in your vehicle's power delivery.

Frequently Asked Questions about Drivetrain for BMW X6 Xdrive 35 I E71 E72

What are the most common signs that the propeller shaft needs replacing on my BMW X6?

The most common symptoms are vibrations throughout the car during acceleration or at speeds between 80–120 km/h. You might also hear a thudding or knocking noise from underneath the vehicle when coming off the throttle or shifting gear.

Do your drive shafts fit both the BMW X6 E71 and the E72 hybrid model?

Yes, we have dedicated parts for both the E71 and E72. By selecting your car's make, model and engine variant, you ensure that you receive the exact version designed for your vehicle's specific drivetrain.

Why is it important to replace a damaged drive shaft boot immediately?

The CV boot protects the CV joint from dirt, water and road grit while retaining the lubricating grease. If it tears, the joint quickly deteriorates due to friction and contamination, leading to a much more expensive replacement of the entire drive shaft.

How does the fitment guarantee work when I buy parts for my BMW X6?

Our fitment guarantee means that if you select your specific car details when ordering and a supplied part unexpectedly fails to fit, we cover the return and exchange for the correct part at no extra cost to you.

Do your drive shaft kits include everything needed for installation?

Yes, our complete drive shafts are supplied fully assembled with CV joints, boots and grease. In most cases, the necessary fixing bolts or nuts are also included to make installation straightforward.

Can a worn prop shaft damage the transfer box on the xDrive system?

Yes, severe vibrations or imbalance from a worn propeller shaft can transmit directly into the transfer box and cause premature wear to bearings and seals, which can result in very costly repairs.