Inner CV joints for BMW 5 Serie

This comprehensive range covers inner CV joints for various BMW 5 Serie models, including saloon, estate and hatchback variants. The selection accommodates both rear-wheel-drive and...

Choose version

Choose a version to refine the results and get closer to the right product.

Products for Inner CV joints for BMW 5 Serie

400 products
241 - 264 of 400
Item no.:246365
  • Position: Front right, Inner
  • Inner splines: 24
  • Seal diameter: 29,97 mm
  • Total length: 484 mm
  • Outer splines: 27
Item no.:644193
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 64,9 mm
  • Total length: 135 mm
  • Outer splines: 30
Item no.:642954
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 43,9 mm
  • Total length: 152 mm
  • Outer splines: 27
Item no.:647081
  • Position: Rear, Inner
  • Inner splines: 28
  • Seal diameter: 65 mm
  • Total length: 139 mm
  • Outer splines: 30
Item no.:643976
  • Position: Rear, Inner
  • Inner splines: 28
  • Seal diameter: 49,9 mm
  • Total length: 158,5 mm
  • Outer splines: 32
Item no.:0456460
  • Position: Front left, Inner
  • Inner splines: 24
  • Seal diameter: 44 mm
  • Total length: 184 mm
  • Joint diameter: 82 mm
Item no.:241695
  • Position: Front right, Inner
  • Inner splines: 24
  • Seal diameter: 44 mm
  • Total length: 485 mm
  • Outer splines: 27
Item no.:0407496
  • Position: Inner
  • Inner splines: 28
  • Seal diameter: 108 mm
  • Total length: 32 mm
  • Joint diameter: 108 mm
Item no.:341513
  • Position: Front right, Inner
  • Inner splines: 28
  • Seal diameter: 50 mm
  • Total length: 300 mm
  • Joint diameter: 102 mm
Item no.:0435647
  • Position: Rear, Inner
  • Inner splines: 25
  • Outer diameter: 100 mm
Item no.:245416
  • Position: Front right, Inner
  • Inner splines: 24
  • Seal diameter: 29,97 mm
  • Total length: 484 mm
  • Outer splines: 27
Item no.:647674
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 64,9 mm
  • Total length: 135 mm
  • Outer splines: 30
Item no.:646110
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 43,9 mm
  • Total length: 152 mm
  • Outer splines: 27
Item no.:640150
  • Position: Rear, Inner
  • Inner splines: 28
  • Seal diameter: 65 mm
  • Total length: 139 mm
  • Outer splines: 30
Item no.:646402
  • Position: Rear, Inner
  • Inner splines: 28
  • Seal diameter: 49,9 mm
  • Total length: 158,5 mm
  • Outer splines: 32
Item no.:0439935
  • Position: Front left, Inner
  • Inner splines: 24
  • Seal diameter: 44 mm
  • Total length: 184 mm
  • Joint diameter: 82 mm
Item no.:247771
  • Position: Front right, Inner
  • Inner splines: 24
  • Seal diameter: 44 mm
  • Total length: 485 mm
  • Outer splines: 27
Item no.:0412597
  • Position: Inner
  • Inner splines: 28
  • Seal diameter: 108 mm
  • Total length: 32 mm
  • Joint diameter: 108 mm
Item no.:344033
  • Position: Front right, Inner
  • Inner splines: 28
  • Seal diameter: 50 mm
  • Total length: 300 mm
  • Joint diameter: 102 mm
Item no.:0445378
  • Position: Rear, Inner
  • Inner splines: 25
  • Outer diameter: 100 mm
Item no.:243474
  • Position: Front right, Inner
  • Inner splines: 24
  • Seal diameter: 29,97 mm
  • Total length: 484 mm
  • Outer splines: 27
Item no.:640518
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 64,9 mm
  • Total length: 135 mm
  • Outer splines: 30
Item no.:646889
  • Position: Rear, Inner
  • Inner splines: 25
  • Seal diameter: 43,9 mm
  • Total length: 152 mm
  • Outer splines: 27
Item no.:644631
  • Position: Rear, Inner
  • Inner splines: 28
  • Seal diameter: 65 mm
  • Total length: 139 mm
  • Outer splines: 30
Showing 241–264 of 400 products

Inner CV joints for BMW 5 Serie

For decades, the BMW 5 Serie has been synonymous with precision engineering and an outstanding driving experience. Maintaining the hallmark balance between comfort and performance demands that every transmission component operates in perfect harmony. The inner CV joint is an often-overlooked yet vital link within this system. At CVJoint24, we offer an extensive range of 57 carefully selected inner CV joints, specifically engineered to satisfy the rigorous technical requirements of the BMW 5 Serie. Our focus is on supplying car parts that meet or exceed original equipment specifications, ensuring your vehicle's drivetrain remains quiet and efficient for many kilometres ahead.

Owning a BMW 5 Serie brings the responsibility of maintaining its sophisticated mechanicals with top-tier spare parts. An inner CV joint endures substantial stresses, particularly in high-torque variants such as the punchy diesels or modern hybrid models. By sourcing an inner constant velocity joint from a specialist, you ensure that material selection and manufacturing tolerances are calibrated precisely for your car's chassis dynamics. This precision is essential to prevent unnecessary wear on adjacent drivetrain components, including the differential and the gearbox output shafts.

What does the inner CV joint do on a BMW 5 Serie?

Unlike the outer CV joint, which primarily accommodates large steering angles, the inner CV joint on a BMW 5 Serie performs a subtler yet equally critical role. It operates as a sliding coupling that allows the drive shaft to adjust its length as the suspension travels up and down. Commonly known as "plunging", this movement is vital because the distance between the fixed gearbox and the articulating wheel hub constantly shifts while driving. Without this flexibility, the driveshaft would either be forced violently into the gearbox casing or pulled clear of its mounting over severe road bumps.

On a BMW 5 Serie, the inner joint is frequently a tripod design or a specialised ball-type assembly engineered to keep friction and heat buildup to a minimum. This mechanical precision is crucial for suppressing micro-vibrations that could otherwise transmit into the passenger cabin and spoil the refined driving experience. A sound inner joint ensures power is delivered smoothly and linearly, whether accelerating briskly along the motorway or negotiating uneven ground in an xDrive model. It is this discreet engineering that keeps your BMW feeling so poised and stable on the road.

Common signs of wear

One of the clearest indicators of a worn inner CV joint on your BMW 5 Serie is vibration that occurs purely under acceleration. While wheel imbalance is typically felt through the steering wheel at set speeds, vibrations caused by an inner joint tend to resonate through the car body and seats. This shaking develops when the joint's internal raceways become pitted or worn, preventing the drive shaft from rotating on a true centre under load. If you notice the shudder vanishing immediately after lifting off the accelerator pedal, it is a very strong sign that the inner CV joints require attention.

Another frequent symptom is an abnormal noise or a dull thud when accelerating from low speeds. It is equally important to inspect the CV boots regularly. When a CV boot splits, its essential lubricating grease escapes while road grit and water penetrate the joint. This rapidly accelerates wear and can cause catastrophic failure if left unaddressed. On a BMW 5 Serie, even a small leak can fling grease onto the exhaust system, producing an unmistakable burning odour. Catching these early warnings can save you from far costlier drivetrain repairs later on.

Choosing the right inner CV joint

Identifying the correct inner CV joint for a BMW 5 Serie demands precision, as specifications vary significantly across production generations and driveline layouts. Spline counts differ considerably on both the drive shaft end and the gearbox or differential side. Furthermore, dimensions often vary between rear-wheel-drive editions and all-wheel-drive (xDrive) models. To ensure you purchase a part with a perfect fit, simply select your car's make, model and engine variant in our store. This filters our catalogue to show only parts technically compatible with your specific vehicle.

Alongside selecting your vehicle's exact make, model and engine, checking physical measurements can be worthwhile if the vehicle has previously been fitted with non-genuine components. Confirm the joint's outer diameter and count the splines if you have the unit removed. When fitting a replacement inner CV joint, always use fresh, high-grade grease and new boot clamps, which are included in our complete kits. Investing in the correct component from the start preserves your car's safety and performance, and the expertise at CVJoint24 ensures you make an informed choice.

Related parts to inspect

Please also inspect these exact pages for the same vehicle when working on the inner CV joint:

When one drivetrain component exhibits wear, adjoining parts on the same car should regularly be inspected as well. By checking these exact pages for the BMW 5 Serie, it is much easier to establish whether a fault lies purely within the inner CV joint or stems from another part of the driveline.

This step is particularly sensible on models where vibration, play and noises can mirror symptoms across several sections of the running gear. Reviewing related categories prevents the frustration of replacing the correct component type while overlooking an adjacent worn part that produces the identical fault.

By checking these related assemblies together, you minimise the need to dismantle the suspension again soon afterwards. A thorough drivetrain inspection ensures your BMW continues to provide the quiet, refined ride expected of the model.

Why shop with CVJoint24?

CVJoint24 is the international shop of a Swedish driveline specialist, dispatching orders across the EU directly from our warehouse in Helsingborg, Sweden. We have built our business on in-depth mechanical knowledge and a commitment to helping drivers find reliable car parts at fair prices. When buying an inner CV joint for your BMW 5 Serie from us, you benefit from our specialist inventory and stringent quality standards. We understand how crucial your car is for daily transport, requiring dependable components whatever the road conditions. Our products are selected specifically to cope with demanding driving throughout European winters and summers alike.

Our catalogue makes finding components effortless by filtering cleanly by vehicle make, model and engine, reducing the chance of ordering an incorrect part. If you ever require guidance, our technical team is ready to assist. We combine the comprehensive stock of a large supplier with the bespoke support of a dedicated specialist. Choosing CVJoint24 means partnering with professionals who put your vehicle's mechanical integrity and road safety first, keeping your BMW 5 Serie running smoothly across Europe.

Frequently asked questions about Inner CV joints for BMW 5 Serie – High quality & perfect fit

What are the most common symptoms of a failing inner CV joint on a BMW 5 Serie?

The most common symptom is vibrations through the car's bodywork during acceleration. Unlike outer CV joints, which click when turning, inner joints typically cause shuddering that disappears when you lift off the accelerator.

Can I replace just the inner CV joint, or do I need to buy a complete drive shaft?

On most BMW 5 Serie models, you can easily replace just the inner CV joint. Provided the drive shaft is otherwise in good condition, this is a cost-effective option, although extensive wear may make a complete drive shaft more economical in the long run.

How do I know which inner CV joint fits my BMW 5 Serie?

The most reliable method is to select your car's make, model, and engine variant on our website. Because specifications differ between rear-wheel drive, xDrive, and various engine sizes, this ensures you get the correct spline count and dimensions.

Why is it important to replace a split inner CV boot straight away?

The CV boot retains the lubricating grease and shields the joint from dirt and water. If it tears, the joint wears out very quickly, which can lead to costly repairs and, in the worst case, the drive shaft detaching.

Do inner CV joints differ between the BMW 5 Serie saloon and Touring?

Usually, the engine, gearbox, and whether the car features xDrive determine which joint fits, rather than the body style itself. However, it is always best to check using your specific model and engine details to be completely certain.

Can a worn inner CV joint damage the gearbox on my BMW?

Yes, severe vibrations from an unbalanced or worn inner CV joint can eventually damage the gearbox output bearings and oil seals. It is therefore vital to rectify the fault as soon as symptoms appear.