KIA Shuma
Car parts and drivetrain components for KIA Shuma.
Products for KIA Shuma
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 22
- Outer splines: 26
- Joint diameter: 78,8 mm
- Position: Front right
- Total length: 371 mm
- Splines gearbox side: 24
- Splines wheel side: 28
- Position: Front left
- Total length: 622 mm
- Splines gearbox side: 24
- Splines wheel side: 28
- ABS teeth: 46
- Position: Front left
- Total length: 612 mm
- Splines gearbox side: 28
- Splines wheel side: 28
- ABS teeth: 46
- Position: Front right
- Total length: 618 mm
- Splines gearbox side: 28
- Splines wheel side: 28
- ABS teeth: 46
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 22
- Outer splines: 28
- Joint diameter: 79 mm
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 24
- Outer splines: 28
- Joint diameter: 87 mm
- Position: Front right
- Total length: 623 mm
- Splines gearbox side: 28
- Splines wheel side: 26
- Position: Front right
- Total length: 623 mm
- Splines gearbox side: 28
- Splines wheel side: 26
- ABS teeth: 44
- Total length: 626 mm
- Splines gearbox side: 24
- Splines wheel side: 26
- ABS teeth: 44
- Position: Front left
- Total length: 626 mm
- Splines gearbox side: 24
- Splines wheel side: 26
- Total length: 635 mm
- Splines gearbox side: 24
- Splines wheel side: 28
- ABS teeth: 46
- Total length: 573 mm
- Splines gearbox side: 28
- Splines wheel side: 28
- ABS teeth: 46
- Position: Outer
- ABS teeth: 44
- Seal diameter: 56 mm
- Inner splines: 24
- Outer splines: 26
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 24
- Outer splines: 26
- Joint diameter: 86,3 mm
- Total length: 615 mm
- Splines gearbox side: 28
- Splines wheel side: 26
- ABS teeth: 44
- Position: Front
- ABS teeth: 44
- Inner diameter: 75 mm
- Outer diameter: 90 mm
- Width: 10 mm
- Position: Front right
- Total length: 624 mm
- Splines gearbox side: 28
- Splines wheel side: 26
- ABS teeth: 44
- Position: Front left
- Total length: 615 mm
- Splines gearbox side: 28
- Splines wheel side: 26
- ABS teeth: 44
- Position: Outer
- ABS teeth: 44
- Seal diameter: 56 mm
- Inner splines: 22
- Outer splines: 26
- Position: Front right
- Total length: 371 mm
- Splines gearbox side: 24
- Splines wheel side: 28
Frequently Asked Questions about Drivetrains for KIA Shuma
How do I know if my KIA Shuma needs a new drive shaft?
The most common symptoms are vibrations throughout the car during acceleration or unusual noises from the underside. If the vibrations stop when you take your foot off the accelerator, it is often an inner CV joint or the drive shaft itself that has worn out.
Do all outer CV joints fit every KIA Shuma model?
No, there can be differences depending on engine size and whether the car is equipped with ABS. Always select your car's make, model and engine to ensure you get a replacement part with the correct spline count and dimensions.
Why is the ABS warning light on in my KIA Shuma?
A very common fault on the KIA Shuma is that the ABS ring on the drive shaft has cracked or corroded away. This causes the wheel speed sensor to lose its signal, which triggers the warning light. We supply replacement ABS rings to resolve this issue.
What is included when I buy an outer CV joint for my KIA Shuma?
Our CV joint kits are normally supplied complete with the constant velocity joint itself, a model-specific CV boot, high-quality grease, circlips and all the necessary clamps for a full installation.
Can I replace just the ABS ring, or do I need to replace the entire drive shaft?
On the KIA Shuma, you can usually replace just the ABS ring if the rest of the drive shaft is in good working order. This is a cost-effective solution, and we offer the correct replacement parts in our range.
How many drive shafts does a KIA Shuma have?
The car is front-wheel drive and therefore has two drive shafts—one on the right side and one on the left side—which both transfer power from the gearbox to the front wheels.