Mitsubishi Colt CZC
Car parts and drivetrain components for Mitsubishi Colt CZC.
Products for Mitsubishi Colt CZC
- Position: Front left
- Total length: 630 mm
- Splines gearbox side: 33
- Splines wheel side: 25
- Position: Front right
- Total length: 925 mm
- Splines gearbox side: 33
- Splines wheel side: 25
- Position: Outer
- Seal diameter: 53 mm
- Inner splines: 21
- Outer splines: 25
- Joint diameter: 75 mm
- Position: Outer
- Inner splines: 21
- Outer diameter: 75 mm
- Splines wheel side: 25
- Total length: 611 mm
- Splines gearbox side: 34
- Splines wheel side: 25
- ABS teeth: 0
- Total length: 927 mm
- Splines gearbox side: 34
- Splines wheel side: 25
- ABS teeth: 0
Frequently Asked Questions about Mitsubishi Colt CZC Drivetrain – High-Quality Spare Parts
How do I know if my Mitsubishi Colt CZC needs a new drive shaft?
The most common signs are heavy vibrations through the car under acceleration or a persistent noise from underneath. If the vibrations stop when you lift off the accelerator, it is often the inner section of the drive shaft that is worn.
Do all CV joints fit all Colt CZC models?
No, there can be differences in spline counts and dimensions depending on the engine and model year. Always select your car's exact make, model and engine to find the right part for your vehicle.
What is included when I buy an outer CV joint from you?
Our outer CV joints are supplied as complete kits. This means you receive the joint itself, a model-specific CV boot, high-quality grease, circlips, and the clamps required for fitting.
Can I replace just the boot if the joint is still intact?
Yes, if you catch a split CV boot early before dirt has entered the joint, you can replace just the boot. This is a very cost-effective preventative measure.
Why is there a clicking noise when I turn in my Mitsubishi Colt CZC?
A clicking noise when turning is the classic symptom of a worn outer CV joint. It is usually caused by lost lubrication or dirt that has caused wear inside the joint's ball tracks.
Is it difficult to replace the drive shaft myself on this model?
It requires some mechanical experience and the correct tools, such as hub nut sockets and pullers. If you are unsure, we recommend consulting a professional garage, but you can conveniently purchase the parts from us.