Nissan Almera I Hatchback
Car parts and drivetrain components for Nissan Almera I Hatchback.
Products for Nissan Almera I Hatchback
- ABS teeth: 42
- Inner diameter: 68 mm
- Outer diameter: 78 mm
- Width: 10 mm
- Position: Front
- ABS teeth: 42
- Inner diameter: 68 mm
- Outer diameter: 78 mm
- Width: 10 mm
- ABS teeth: 44
- Inner diameter: 68 mm
- Outer diameter: 78 mm
- Width: 9,5 mm
- Position: Outer
- ABS teeth: 42
- Seal diameter: 55 mm
- Inner splines: 23
- Outer splines: 25
- Position: Inner
- Seal diameter: 40 mm
- Inner splines: 23
- Diameter: 40 mm
- Splines gearbox side: 24
- Position: Outer
- Seal diameter: 55 mm
- Inner splines: 22
- Outer splines: 25
- Joint diameter: 82 mm
- Position: Front
- Diameter: 85 mm
- Total length: 102 mm
- Outer diameter: 24 mm
- Position: Inner
- Seal diameter: 40 mm
- Total length: 162 mm
- Outer diameter: 79 mm
- Total length: 625 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- Total length: 635 mm
- Splines gearbox side: 24
- Splines wheel side: 25
- Total length: 925 mm
- Splines gearbox side: 24
- Splines wheel side: 25
- Total length: 635 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- Total length: 635 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- ABS teeth: 42
- Total length: 917 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- Total length: 917 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- ABS teeth: 42
- Total length: 592 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- Position: Front left
- Total length: 592 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- ABS teeth: 42
- Total length: 960 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- Total length: 960 mm
- Splines gearbox side: 25
- Splines wheel side: 25
- ABS teeth: 42
- Position: Front
- ABS teeth: 42
- Inner diameter: 68 mm
- Outer diameter: 78 mm
- Width: 10 mm
- Position: Outer
- Seal diameter: 55 mm
- Inner splines: 23
- Outer splines: 25
- Joint diameter: 90 mm
Frequently Asked Questions about Drivetrain for Nissan Almera I Hatchback
How do I know if my Nissan Almera I Hatchback needs a new outer CV joint?
The most common symptom is a clicking or knocking noise when cornering on full lock. If the noise disappears when driving straight ahead, it is almost certainly a worn outer CV joint.
Can I replace just the ABS ring on my Almera I?
Yes, on many Nissan Almera I Hatchback models the ABS ring can be replaced separately if it has cracked or corroded, provided that the CV joint itself is still in good condition.
Why is the ABS warning light on in my Nissan Almera?
A very common cause on this model is a cracked ABS ring. Rust builds up beneath the ring and expands it until it snaps, preventing the sensor from accurately reading wheel rotation.
What parts are included when I buy an outer CV joint from you?
Our kits normally include the CV joint itself, a new CV boot, grease, securing clips and, where applicable, a new centre bolt or hub nut to ensure a complete and reliable installation.
How do I find the correct number of splines for my drive shaft?
The most reliable method is to filter by your car's exact make, model and engine variant. If multiple options are listed for your vehicle, we recommend counting the splines on your existing part before ordering.
Is it difficult to replace a CV joint on a Nissan Almera I Hatchback?
It requires some mechanical know-how and the right tools, such as pullers and a torque wrench. However, for a confident DIY mechanic, it is a perfectly manageable job.