Renault Megane I Classic
Car parts and drivetrain components for Renault Megane I Classic.
Products for Renault Megane I Classic
- ABS teeth: 44
- Inner diameter: 75 mm
- Outer diameter: 85 mm
- Width: 7,5 mm
- Position: Front
- ABS teeth: 44
- Inner diameter: 75 mm
- Outer diameter: 85 mm
- Width: 7,5 mm
- Position: Outer
- ABS teeth: 44
- Seal diameter: 52,2 mm
- Inner splines: 30
- Outer splines: 21
- Position: Front left
- Total length: 648 mm
- Splines wheel side: 21
- ABS teeth: 44
- Position: Front right
- Total length: 738 mm
- Splines gearbox side: 23
- Splines wheel side: 21
- ABS teeth: 44
- Position: Front left
- Total length: 653 mm
- Splines wheel side: 23
- ABS teeth: 44
- Position: Outer
- ABS teeth: 44
- Seal diameter: 51 mm
- Inner splines: 22
- Outer splines: 21
- Position: Front left
- Total length: 648 mm
- Splines wheel side: 21
- Position: Front right
- Total length: 745 mm
- Splines gearbox side: 23
- Splines wheel side: 21
- Position: Outer
- ABS teeth: 44
- Seal diameter: 57 mm
- Inner splines: 30
- Outer splines: 23
- Position: Front right
- Total length: 752 mm
- Splines gearbox side: 23
- Splines wheel side: 23
- ABS teeth: 44
- Position: Front left
- Total length: 706 mm
- Splines wheel side: 23
- Position: Outer
- ABS teeth: 44
- Seal diameter: 57 mm
- Inner splines: 35
- Outer splines: 23
- Position: Front right
- Total length: 738 mm
- Splines gearbox side: 23
- Splines wheel side: 21
- ABS teeth: 44
- Position: Front, Outer
- Inner splines: 25
- Outer diameter: 90 mm
- Splines wheel side: 23
- ABS teeth: 44
- Position: Front, Outer
- Inner splines: 25
- Outer diameter: 90 mm
- Splines wheel side: 23
- Position: Front, Outer
- Inner splines: 30
- Outer diameter: 84 mm
- Splines wheel side: 23
- ABS teeth: 44
- Position: Front, Outer
- Inner splines: 32
- Outer diameter: 88 mm
- Splines wheel side: 23
- ABS teeth: 44
- Position: Front right
- Total length: 739 mm
- Splines gearbox side: 23
- Splines wheel side: 21
- Position: Front left
- Total length: 630 mm
- Splines gearbox side: 26
- Splines wheel side: 23
- ABS teeth: 44
- Position: Outer
- Inner splines: 30
- Outer diameter: 84 mm
- Splines wheel side: 21
- ABS teeth: 44
- Position: Front, Outer
- Inner splines: 30
- Outer diameter: 84 mm
- Splines wheel side: 21
Frequently Asked Questions about Drivetrain Parts for Renault Megane I Classic
How do I know if my Renault Megane I Classic needs a new drive shaft?
The most common signs are vibrations under acceleration or a clicking noise when cornering. If the vibrations can be felt throughout the car, it is often the inner joint or the shaft itself that is unbalanced.
Can I replace just the ABS ring on my Megane I Classic?
Yes, if your outer CV joint is otherwise in good condition, you can replace just the ABS ring. It is a common and cost-effective repair when the ABS warning light comes on due to a cracked ring.
Why is there a clicking noise from the front suspension when I turn?
This is usually caused by a worn outer CV joint. When excessive play develops around the bearings inside the joint, it produces a clicking sound that becomes more pronounced at sharper steering angles.
Do all drive shafts fit all engine variants of the Megane I Classic?
No, drive shafts vary depending on whether the car has a manual or automatic gearbox, as well as the engine size. Always select your specific vehicle model and engine to find the correct version.
What happens if I drive with a split CV boot?
If the boot is split, the grease leaks out and road dirt penetrates inside. This rapidly wears down the CV joint and ultimately causes it to fail, which is far more expensive than replacing the CV boot in good time.
How many teeth should the ABS ring have on a Renault Megane I Classic?
This varies between different models, but common counts are 26 or 44 teeth. The safest method is to count the teeth on the old ring or select your vehicle make, model and engine variant in our shop.