Skoda Fabia 1.6
Car parts and drivetrain components for Skoda Fabia 1.6. Always check the fit before ordering.
Products for Skoda Fabia 1.6
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- Seal diameter: 52 mm
- Inner splines: 30
- Outer splines: 36
- Joint diameter: 85 mm
- Position: Front left
- Total length: 554 mm
- Splines gearbox side: 26
- Splines wheel side: 36
- Position: Front left
- Flange diameter: 94 mm
- Total length: 501 mm
- Splines wheel side: 36
- Position: Front right
- Total length: 855 mm
- Splines gearbox side: 26
- Splines wheel side: 36
- Position: Front right
- Flange diameter: 100 mm
- Total length: 752 mm
- Splines wheel side: 36
- Position: Outer
- Seal diameter: 52 mm
- Inner splines: 30
- Outer splines: 36
- Joint diameter: 90 mm
- Position: Front right
- Flange diameter: 94 mm
- Total length: 758 mm
- Splines wheel side: 36
- Position: Front left
- Flange diameter: 100 mm
- Total length: 505 mm
- Splines wheel side: 36
- Position: Front right
- Flange diameter: 100 mm
- Total length: 782 mm
- Splines wheel side: 36
- ABS teeth: 0
- Position: Front left
- Diameter: 83 mm
- Flange diameter: 100 mm
- Total length: 524 mm
- ABS teeth: 0
- Position: Front left
- Total length: 565 mm
- Splines gearbox side: 26
- Splines wheel side: 36
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Number of joints: 3
- ABS teeth: 0
- Position: Front left
- Total length: 565 mm
- Splines gearbox side: 26
- Splines wheel side: 36
Frequently Asked Questions about Drivetrain for Skoda Fabia 1.6
How do I know if I need to replace the entire drive shaft or just the CV joint on my Skoda Fabia 1.6?
If vibrations persist despite replacing the joint, or if the shaft itself is bent or heavily corroded at the contact surfaces, the complete drive shaft should be replaced. For the DIY mechanic, fitting a complete driveshaft is often much simpler.
Does the same drive shaft fit both the right and left side on a Fabia 1.6?
No, the length usually differs between the right and left drive shaft due to the position of the gearbox. Always check the specifications for each side before ordering.
What tools are needed to replace an outer CV joint on a Skoda Fabia 1.6?
You generally need a heavy-duty socket for the hub nut, a puller or hammer to release the joint, and specialised pliers to secure the new CV boot clamps.
Are the CV boot and grease included when I buy a CV joint from you?
Yes, our CV joints are supplied as complete kits containing the joint, CV boot, specialist grease, circlips, and fitting hardware to ensure a correct installation.
How often should I inspect the condition of the drivetrain?
We recommend a visual inspection of the CV boots at every service or tyre change. An intact boot is the best protection against costly constant velocity joint failure.
What happens if I continue driving with a split CV boot on my Skoda Fabia?
When the boot splits, grease escapes and dirt enters. This causes extremely rapid wear and can, in the worst case, cause the joint to seize completely, posing a serious safety hazard.