Vauxhall Vivaro B Van
Car parts and drivetrain components for Vauxhall Vivaro B Van.
Products for Vauxhall Vivaro B Van
- Position: Front left
- Total length: 695 mm
- Splines gearbox side: 39
- Splines wheel side: 29
- ABS teeth: 0
- Position: Front right
- Total length: 1,020 mm
- Splines gearbox side: 39
- Splines wheel side: 29
- ABS teeth: 0
- Position: Front, Outer
- Seal diameter: 60 mm
- Inner splines: 28
- Diameter: 60 mm
- Splines wheel side: 29
Frequently Asked Questions about Drivetrain for Vauxhall Vivaro B Van
How do I know if my Vauxhall Vivaro B Van needs a new drive shaft?
The most common signs are heavy vibrations during acceleration or unusual noises while driving. If you notice that the vibrations disappear as soon as you ease off the throttle, it is often the inner joint of the drive shaft that has worn out.
What causes a clicking noise when turning in my Vivaro B?
A clicking noise on full lock is almost always caused by a worn outer CV joint. This often happens because a CV boot has split, allowing dirt and moisture to penetrate the moving parts of the joint.
Can I replace just the CV joint, or do I need to replace the entire drive shaft?
On the Vauxhall Vivaro B Van, you can often replace the outer CV joint separately. However, if the shaft is corroded or the inner joint is also worn, replacing the complete drive shaft is usually more economical and reliable.
Do all drive shafts fit all Vivaro B models?
No, there are differences depending on engine size and whether the van has a manual or automatic gearbox. Always select your vehicle's make, model and engine on cvjoint24.com to ensure the correct fitment.
How often should I check the CV boots on my van?
We recommend inspecting the CV boots at every service or tyre change. Because the Vivaro B is frequently driven in demanding conditions, the risk of mechanical damage to the rubber is higher.
What is included when I buy an outer CV joint from you?
When you purchase an outer CV joint for your Vauxhall Vivaro B Van, it typically includes the joint itself, a new CV boot, grease, clamps and any circlip or bolt required for installation.