Volkswagen Passat 2.8 V6 Syncro
Car parts and drivetrain components for Volkswagen Passat 2.8 V6 Syncro. Always check the fit before ordering.
Products for Volkswagen Passat 2.8 V6 Syncro
- Position: Front left
- Flange diameter: 130 mm
- Total length: 625 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Rear left
- Flange diameter: 130 mm
- Total length: 526 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 500 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Position: Outer
- ABS teeth: 45
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
- Position: Front left
- Flange diameter: 130 mm
- Total length: 602 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Rear left, Rear right
- Flange diameter: 100 mm
- Total length: 618 mm
- Splines wheel side: 33
- ABS teeth: 45
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front
- Diameter: 91 mm
- Outer diameter: 24 mm
- Position: Front right
- Diameter: 86 mm
- Flange diameter: 100 mm
- Total length: 640 mm
- ABS teeth: 45
- Position: Front left
- Flange diameter: 130 mm
- Total length: 601 mm
- Splines wheel side: 38
- ABS teeth: 45
- Flange diameter: 124 mm
- Total length: 615 mm
- Splines wheel side: 38
- Total length: 625 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Number of joints: 3
- ABS teeth: 0
- Position: Outer
- ABS teeth: 45
- Seal diameter: 60 mm
- Inner splines: 30
- Outer splines: 38
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
Frequently asked questions about drivetrain parts for Volkswagen Passat 2.8 V6 Syncro
How do I know if a CV joint is faulty on my Passat Syncro?
The most common symptoms are a clicking noise when turning sharply (outer CV joint) or vibrations through the car during acceleration (inner CV joint). Also check whether the CV boot is split or cracked.
Does the same drive shaft fit both the front and rear axles?
No, on the Volkswagen Passat 2.8 V6 Syncro, the front and rear drive shafts differ in both length and design. Always select your exact make, model and engine variant to find the correct fitting position.
Why is the ABS warning light on in my Volkswagen Passat?
On this model, a cracked or corroded ABS ring is a very common cause. The ring sits on the CV joint and sends signals to the ABS sensor; if it fails, the warning light illuminates.
What is included when I buy an outer CV joint from you?
Our CV joint kits are normally supplied complete with the joint itself, CV boot, grease, clips and mounting hardware such as the bolt or nut to ensure a straightforward replacement.
Is it difficult to replace a drive shaft on a Syncro model?
It requires some mechanical experience and the correct tools, especially as the Syncro four-wheel-drive system has a more compact assembly around the rear axle. We recommend following the vehicle's workshop manual closely.
How quickly can I receive my spare parts?
We aim to dispatch in-stock items promptly so you can get your Volkswagen Passat 2.8 V6 Syncro back on the road without delay.