Audi 100 2.6 Quattro
Car parts and drivetrain components for Audi 100 2.6 Quattro. Always check the fit before ordering.
Products for Audi 100 2.6 Quattro
- Position: Front right
- Flange diameter: 108 mm
- Total length: 662 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 30
- Outer splines: 38
- Position: Outer
- ABS teeth: 45
- Seal diameter: 60 mm
- Inner splines: 25
- Outer splines: 38
- Position: Front
- ABS teeth: 45
- Inner diameter: 64 mm
- Outer diameter: 74 mm
- Width: 8,1 mm
- Position: Inner
- ABS teeth: 0
- Inner splines: 28
- Joint diameter: 108 mm
- Outer diameter: 108 mm
- Position: Outer
- Inner splines: 30
- Outer diameter: 90 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Outer
- Inner splines: 30
- Outer diameter: 90 mm
- Splines wheel side: 38
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 30
- Outer splines: 38
Frequently Asked Questions about Drivetrain for Audi 100 2.6 Quattro
How do I know if my Audi 100 2.6 Quattro needs a new drive shaft?
Common signs include severe vibrations during acceleration or unusual noises when cornering. If the CV boot has split and grease has leaked out, the joints wear down quickly and the entire shaft may need replacing to restore proper function.
Does the same CV joint fit both the front and rear axles?
No, on the Audi 100 2.6 Quattro the components differ between the front and rear axle. It is therefore essential to select your exact model and engine variant to ensure you choose the correct position for your repair.
Why is the ABS warning light on after replacing a CV joint?
This is often because the ABS ring on the new joint does not match the car's sensor or the ring was damaged during installation. Always check that the tooth count on the new ABS ring is identical to the original part.
What is the benefit of buying a complete drive shaft rather than just a CV joint?
A complete drive shaft saves installation time and guarantees that both inner and outer joints are in pristine condition. It eliminates the risk of an old inner joint causing vibrations after the outer CV joint has been replaced.
How does the Quattro system affect drivetrain wear?
All-wheel drive distributes power across more components, but it also introduces more moving parts that can wear over time. It is vital to use tyres with matching rolling circumferences to avoid placing unnecessary strain on differentials and drive shafts.
Can I replace just the ABS ring on my Audi 100?
Yes, if the CV joint itself is in good condition but the ABS ring has cracked due to corrosion, you can replace just the ring. We supply individual ABS rings specifically matched to the Audi 100 2.6 Quattro.