Audi
Car parts and drivetrain components for Audi.
Products for Audi
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 25
- Outer splines: 42
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 469 mm
- Splines wheel side: 42
- Position: Rear left, Rear right
- Flange diameter: 100 mm
- Total length: 626 mm
- Splines wheel side: 42
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,630 mm
- Position: Rear left
- Total length: 587 mm
- Splines wheel side: 42
- Position: Rear right
- Total length: 545 mm
- Splines wheel side: 42
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 495 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 29
- Outer splines: 42
- Position: Front right
- Total length: 817 mm
- Splines gearbox side: 40
- Splines wheel side: 36
- Position: Front left
- Flange diameter: 108 mm
- Total length: 523 mm
- Splines wheel side: 36
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,640 mm
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 660 mm
- Splines wheel side: 42
- Position: Rear left
- Total length: 620 mm
- Splines wheel side: 42
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,525 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,477 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,645 mm
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- Joint diameter: 100 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,633 mm
- Position: Front left
- Flange diameter: 100 mm
- Total length: 520 mm
- Splines wheel side: 36
Frequently Asked Questions about Drivetrains for Audi – Power Transmission Spare Parts
How do I know if my Audi needs a new outer CV joint?
The most common symptom is a clicking or knocking noise when cornering, especially on full lock at low speeds. If the noise disappears when driving straight ahead, it is almost certainly a worn outer CV joint.
Does the same drive shaft fit all Audi A4 models?
No, drive shafts vary depending on the generation (e.g. B7, B8, B9), engine type, gearbox, and whether the car has Quattro four-wheel drive or front-wheel drive. Always select your specific make, model and engine to find the correct shaft.
Why does my Audi vibrate under acceleration?
Vibrations under load are often caused by wear in the inner CV joints. If the vibration stops as soon as you lift off the accelerator, this is a strong indication that an inner constant velocity joint needs replacing.
Can I replace just the ABS ring on my Audi?
Yes, on many Audi models the ABS ring is mounted onto the CV joint and can be replaced separately if it has cracked or corroded, making it a cost-effective alternative to replacing the entire joint.
What is the difference between drive shafts for Quattro and front-wheel-drive models?
Quattro models have drive shafts both front and rear, and the front driveshafts often differ in length and design compared to front-wheel-drive models due to the layout and position of the differential.
How often should I inspect the CV boots on my Audi?
We recommend checking them at every service or seasonal tyre change. A split CV boot quickly allows road dirt to ruin the CV joint, so catching a tear early can save you substantial repair costs.
Do you sell complete drive shafts for Audi or only individual joints?
We supply both. For many models, fitting a complete drive shaft is the quickest and most straightforward option, whereas in other cases it is more economical to replace only the worn CV joint using one of our complete repair kits.