Audi A5 Sportback
Car parts and drivetrain components for Audi A5 Sportback.
Products for Audi A5 Sportback
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,640 mm
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 25
- Outer splines: 42
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 469 mm
- Splines wheel side: 42
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,630 mm
- Position: Rear left, Rear right
- Flange diameter: 100 mm
- Total length: 626 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 29
- Outer splines: 42
- Position: Rear left
- Total length: 587 mm
- Splines wheel side: 42
- Position: Rear right
- Total length: 545 mm
- Splines wheel side: 42
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,529 mm
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- Joint diameter: 100 mm
- Position: Rear left, Rear right
- Flange diameter: 100 mm
- Total length: 630 mm
- Splines wheel side: 42
- Diameter: 30 mm
- Hole spacing c/c: 228 mm
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 33
- Outer splines: 42
- Joint diameter: 88 mm
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,493 mm
- Position: Outer
- Seal diameter: 77 mm
- Inner splines: 29
- Outer splines: 42
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 632 mm
- Splines wheel side: 42
- Diameter: 30 mm
- Height: 102 mm
- Hole spacing c/c: 228 mm
- Inner diameter: 30 mm
- Bearing thickness: 15 mm
Frequently Asked Questions about Drivetrain for Audi A5 Sportback – Spare Parts with a Perfect Fit
How do I know if my Audi A5 Sportback needs a new drive shaft?
The most common signs are vibrations under acceleration or unusual noises while driving. If the vibrations can be felt throughout the car, it is often the inner joint or the shaft itself that is worn or unbalanced.
Is there a difference between drive shafts for front-wheel drive and Quattro?
Yes, there is a significant difference. Quattro models use specific drive shafts both front and rear, and their lengths and mountings often differ from front-wheel-drive models. Always select your make, model and engine to ensure the correct fit.
Why is there a clicking sound when turning in my Audi A5 Sportback?
A clicking noise on full steering lock is a classic symptom of a worn outer CV joint. This is usually caused by dirt penetrating the joint through a split or damaged CV boot.
Can I replace just the CV joint, or do I need to replace the entire drive shaft?
On most Audi A5 Sportback models, you can easily replace just the outer or inner CV joint, provided the shaft itself is neither damaged nor bent.
What is included when I buy a CV joint from CVJoint24?
Our CV joint kits are supplied complete with the joint, model-specific CV boot, high-grade grease, clamps, and, where required, a new centre bolt or circlip.
How often should I inspect the CV boots on my Audi A5 Sportback?
We recommend inspecting the CV boots at every routine service or seasonal tyre change. An intact boot is the most cost-effective insurance against an expensive CV joint replacement.
Does the same CV joint fit both the left and right sides?
In most cases, the front outer CV joints are identical on both sides, but this can vary for inner joints as well as for the rear axle on Quattro models. Always check the detailed product specifications.