Audi 200 Avant
Car parts and drivetrain components for Audi 200 Avant.
Products for Audi 200 Avant
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Joint diameter: 90 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 28
- Outer splines: 38
- Position: Outer
- ABS teeth: 45
- Seal diameter: 60 mm
- Inner splines: 25
- Outer splines: 38
- ABS teeth: 45
- Inner diameter: 64 mm
- Outer diameter: 74 mm
- Width: 8,1 mm
- Position: Front
- ABS teeth: 45
- Inner diameter: 64 mm
- Outer diameter: 74 mm
- Width: 8,1 mm
- Position: Outer
- ABS teeth: 96
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 28
- Outer splines: 26
- Joint diameter: 99,9 mm
- Position: Outer
- ABS teeth: 96
- Seal diameter: 57 mm
- Inner splines: 28
- Outer splines: 26
- ABS teeth: 96
- Inner diameter: 64 mm
- Outer diameter: 73 mm
- Width: 8,1 mm
- Position: Outer
- ABS teeth: 48
- Seal diameter: 56 mm
- Inner splines: 18
- Outer splines: 28
- Position: Inner
- ABS teeth: 0
- Inner splines: 28
- Joint diameter: 108 mm
- Outer diameter: 108 mm
- Position: Inner
- Inner splines: 26
- Joint diameter: 119 mm
- Position: Outer
- Inner splines: 30
- Outer diameter: 90 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Outer
- Inner splines: 30
- Outer diameter: 90 mm
- Splines wheel side: 38
- Position: Outer
- Inner splines: 25
- Outer diameter: 90 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Joint diameter: 90 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 28
- Outer splines: 38
Frequently Asked Questions about Drivetrain for Audi 200 Avant - High-Quality Spare Parts
How do I know if my Audi 200 Avant needs a new outer CV joint?
The most common symptom is a clicking noise coming from the front suspension when making sharp turns at low speed. If the noise stops when driving in a straight line, it is almost certainly the outer CV joint.
Can I replace just the ABS ring on my Audi 200 Avant?
Yes, if the CV joint itself is in good condition, you can replace just the ABS ring. This is a cost-effective solution if the ring has cracked due to corrosion while the joint continues to work flawlessly.
Why does my Audi 200 Avant vibrate during acceleration?
Vibrations under load, especially when accelerating, are often caused by wear in the inner CV joints. These joints manage power transmission closest to the gearbox, and vibrations occur when excessive play develops.
How many CV joints are fitted to an Audi 200 Avant?
A front-wheel-drive Audi 200 Avant has four CV joints in total: two outer joints at the wheels and two inner joints by the gearbox. Four-wheel-drive models feature additional joints for the rear axle.
Do all ABS rings fit all Audi 200 Avant models?
No, the tooth count and the ring's diameter can vary depending on the model year and braking system. Always select your car's make, model and engine to find the correct specification.
Is it necessary to replace the CV boot at the same time as the CV joint?
When you purchase a new CV joint from us, a new CV boot, grease and fitting accessories are usually included. It is essential to use an intact boot to protect the new constant velocity joint against dirt and moisture.