Audi 100 Avant
Car parts and drivetrain components for Audi 100 Avant.
Products for Audi 100 Avant
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Joint diameter: 90 mm
- Position: Outer
- ABS teeth: 96
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Position: Outer
- ABS teeth: 45
- Seal diameter: 60 mm
- Inner splines: 25
- Outer splines: 38
- Position: Front right
- Flange diameter: 108 mm
- Total length: 662 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 30
- Outer splines: 38
- Position: Front
- ABS teeth: 45
- Inner diameter: 64 mm
- Outer diameter: 74 mm
- Width: 8,1 mm
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Position: Front left
- Flange diameter: 130 mm
- Total length: 613 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 648 mm
- Splines wheel side: 33
- Position: Front right
- Flange diameter: 130 mm
- Total length: 648 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Position: Front left
- Flange diameter: 130 mm
- Total length: 613 mm
- Splines wheel side: 38
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 28
- Outer splines: 38
- Position: Outer
- ABS teeth: 48
- Seal diameter: 56 mm
- Inner splines: 18
- Outer splines: 28
- Position: Front left
- Flange diameter: 130 mm
- Total length: 565 mm
- Splines wheel side: 38
- ABS teeth: 45
Frequently Asked Questions about Drivetrain for Audi 100 Avant - Spare Parts & Expertise
How do I know which CV joint fits my Audi 100 Avant?
The easiest and most reliable way is to select your car's make, model and engine in our search filter. This narrows our range of 133 parts down to those that fit your specific Audi 100 Avant. We also recommend checking the spline count and dimensions stated on the product page.
What are the most common signs of a failing drive shaft?
Common symptoms include severe vibrations under acceleration, unusual noises from underneath the vehicle, or in the worst case, complete loss of drive. If you notice an imbalance, you should inspect both the inner and outer CV joints.
Why is the ABS warning light on in my Audi 100 Avant?
This is often caused by a cracked, corroded or fouled ABS ring located on the outer CV joint. We stock 23 different ABS rings for the Audi 100 Avant so you can quickly resolve the issue.
Is there a difference between the inner and outer CV joint?
Yes, the outer CV joint is located closest to the wheel and accommodates steering angles, whereas the inner joint sits next to the gearbox and accommodates suspension travel. They also produce different fault symptoms: outer joints click when cornering, whilst inner joints vibrate under acceleration.
Can I replace just the CV boot instead of the entire joint?
If you catch a split CV boot early enough, before dirt and moisture have entered to damage the joint itself, replacing the boot and repacking it with fresh grease is often sufficient. However, if unusual noises can already be heard, the entire constant velocity joint must be replaced.
How many drive shafts does an Audi 100 Avant have?
A front-wheel-drive Audi 100 Avant has two front drive shafts. If the car is equipped with Quattro four-wheel drive, it also features rear driveshafts and a propeller shaft.
Why does the car vibrate under acceleration?
Vibrations under acceleration are a classic symptom of wear in the inner CV joints. This is usually caused by pitting or grooving in the joint housing where the balls or rollers run, creating an imbalance under load.