Audi 80 1.6 GT
Car parts and drivetrain components for Audi 80 1.6 GT. Always check the fit before ordering.
Products for Audi 80 1.6 GT
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Joint diameter: 94 mm
- Position: Inner
- Seal diameter: 78 mm
- Inner splines: 33
- Joint diameter: 92 mm
- Outer diameter: 92 mm
Frequently Asked Questions about Drivetrain Parts for Audi 80 1.6 GT
What are the most common signs of a worn outer CV joint on my Audi 80 1.6 GT?
The most common symptom is a clicking or knocking noise when making sharp turns while driving. The sound usually quickens with the vehicle's speed and stops when you are driving straight ahead.
Do all Audi 80 CV joints fit my 1.6 GT model?
No, there can be differences in spline counts and dimensions across different engine options and model years. Always use our vehicle selector to choose your make, model and engine to ensure the correct fit.
Why does my Audi 80 1.6 GT vibrate under acceleration?
Vibrations under load, especially during acceleration, are frequently caused by wear in the inner CV joints. When these become worn, play develops that creates an imbalance in the drive shaft.
Do I need to replace the entire drive shaft if only the joint is damaged?
In most cases, it is sufficient to replace just the specific CV joint (inner or outer) provided the shaft itself is straight and undamaged. This is a much more cost-effective solution than replacing the complete driveshaft.
Are the CV boot and grease included when I buy a CV joint from you?
Yes, our CV joint kits come complete with a CV boot, high-quality grease, clamps and any necessary fitting hardware such as bolts or nuts to make installation straightforward.
How does your fitment guarantee work for Audi parts?
Our fitment guarantee means that if you have selected your exact make, model and engine and we have confirmed the component, we guarantee it will fit. In the unlikely event that it does not, we will help you find the correct part at no extra cost.