Audi 80 1.8 S Quattro
Car parts and drivetrain components for Audi 80 1.8 S Quattro. Always check the fit before ordering.
Products for Audi 80 1.8 S Quattro
- Position: Front left
- Flange diameter: 100 mm
- Total length: 586 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front right
- Flange diameter: 100 mm
- Total length: 573 mm
- Splines wheel side: 33
- ABS teeth: 45
- Diameter: 30 mm
- Height: 41 mm
- Hole spacing c/c: 130 mm
- Bearing thickness: 15 mm
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Joint diameter: 94 mm
- Position: Outer
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Joint diameter: 90 mm
- Position: Outer
- Seal diameter: 51 mm
- Inner splines: 30
- Outer splines: 22
- Position: Outer
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
- Joint diameter: 87,8 mm
- Position: Outer
- ABS teeth: 96
- Seal diameter: 51 mm
- Inner splines: 30
- Outer splines: 22
- Position: Outer
- ABS teeth: 96
- Seal diameter: 56 mm
- Inner splines: 25
- Outer splines: 26
- Position: Rear right
- Total length: 598 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Rear left
- Total length: 556 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front left
- Total length: 633 mm
- Splines wheel side: 22
- ABS teeth: 96
- Position: Front right
- Total length: 620 mm
- Splines wheel side: 22
- ABS teeth: 96
Frequently asked questions about drivetrain parts for Audi 80 1.8 S Quattro
How do I know if my Audi 80 1.8 S Quattro needs a new drive shaft?
Common signs include noticeable vibrations under acceleration or abnormal noises from the underbody. On a Quattro model, worn drive shafts can also compromise how the four-wheel-drive system responds in slippery conditions.
Do all Audi 80 CV joints fit my Quattro model?
No, Quattro models often feature specific dimensions and spline counts compared to front-wheel-drive variants. Always select your exact make, model and engine to ensure the correct fit.
Why does my car vibrate under acceleration?
Vibration during acceleration is often caused by wear in the inner CV joints or an imbalance in the propeller shaft. It is important to inspect these parts to prevent secondary damage to the gearbox.
Is it difficult to replace the ABS ring on an Audi 80?
It requires removing the CV joint to access the ring. This is a common job on older Audi models, where corrosion often causes the original ring to crack.
What is included when I buy a CV joint from you?
Our CV joint kits come complete with the CV joint, CV boot, grease, clamps and the necessary mounting bolts or nuts for a straightforward installation.
How quickly can I receive the parts for my Audi?
We dispatch quickly from our Swedish central warehouse across the EU, helping you get your Audi 80 1.8 S Quattro back on the road without unnecessary delay.