Audi 80 2.0 E
Car parts and drivetrain components for Audi 80 2.0 E. Always check the fit before ordering.
Products for Audi 80 2.0 E
- Position: Front left
- Flange diameter: 100 mm
- Total length: 586 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front right
- Flange diameter: 100 mm
- Total length: 573 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
- Joint diameter: 87,8 mm
- Position: Front
- ABS teeth: 45
- Inner diameter: 64 mm
- Outer diameter: 74 mm
- Width: 8,1 mm
- Position: Front right
- Flange diameter: 130 mm
- Total length: 557 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front left
- Total length: 470 mm
- Splines wheel side: 33
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Joint diameter: 94 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
Frequently Asked Questions about Drivetrain Parts for Audi 80 2.0 E
How do I know if my Audi 80 2.0 E needs a new outer CV joint?
The most common sign is a clicking or knocking noise when cornering, especially on full lock at low speeds. If the sound disappears when driving in a straight line, it is almost certainly the outer CV joint that has worn out.
Can I replace just the ABS ring, or do I have to replace the complete CV joint?
On the Audi 80 2.0 E, it is often possible to replace just the ABS ring if the CV joint itself is otherwise in good working order. We supply separate ABS rings to provide a more cost-effective repair.
Why is my car vibrating during acceleration?
Vibrations under load are often caused by wear in the inner CV joint. When excessive play develops, the joint can no longer centre the drive shaft properly, resulting in an imbalance and vibrations felt throughout the entire vehicle.
Does the same drive shaft fit both the left and right sides?
This depends on the gearbox type and model year. Always select your specific make, model and engine variant on our website to ensure you find the exact drive shaft required for each side of your Audi 80 2.0 E.
What is included when I buy a CV joint kit from you?
Our kits come complete and ready for installation. They typically contain the CV joint, CV boot, specialised grease, clamps and, where required, the centre bolt or nut and circlip.
How quickly can I get my parts delivered?
We dispatch quickly across Europe from our central warehouse for products in stock, ensuring fast and dependable delivery directly to your door.