Audi A3 Saloon 35 Tfsi
Car parts and drivetrain components for Audi A3 Saloon 35 Tfsi. Always check the fit before ordering.
Products for Audi A3 Saloon 35 Tfsi
- Position: Outer
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 36
- Joint diameter: 97,95 mm
- Position: Front right
- Total length: 817 mm
- Splines gearbox side: 40
- Splines wheel side: 36
- Position: Front left
- Flange diameter: 108 mm
- Total length: 523 mm
- Splines wheel side: 36
- Position: Front left
- Flange diameter: 108 mm
- Joint diameter: 108 mm
- Total length: 495 mm
- Splines wheel side: 36
- Position: Front right
- Flange diameter: 108 mm
- Joint diameter: 108 mm
- Total length: 795 mm
- Splines wheel side: 36
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Number of joints: 3
- ABS teeth: 0
- Position: Front left
- Flange diameter: 100 mm
- Total length: 524 mm
- Splines wheel side: 36
Frequently Asked Questions about Drivetrain for Audi A3 Saloon 35 Tfsi
How do I know if my Audi A3 Saloon 35 Tfsi needs a new drive shaft?
The most common signs are vibrations under acceleration or noises when cornering. If vibrations are felt throughout the car when accelerating, the drive shaft or the inner CV joint is often the culprit.
What is the difference between the inner and outer CV joint on my Audi?
The outer CV joint is located by the wheel and allows for steering; it often makes a clicking noise when turning if worn. The inner joint sits by the gearbox and accommodates suspension travel; it usually causes vibrations during acceleration.
Can I replace just the CV boot on my Audi A3?
Yes, if you catch the damage early before dirt has entered the joint, replacing just the CV boot and repacking it with fresh grease may suffice. If the joint has already started making noise, the complete CV joint or drive shaft must be replaced.
Does the same drive shaft fit both manual and S-tronic gearboxes?
Usually not. Drive shafts often differ in length and mounting depending on the gearbox type. Always select your specific make, model and engine to get the correct version for your 35 Tfsi.
Why is there a clicking sound when turning in my Audi A3 Saloon?
A clicking noise at full steering lock is a classic symptom of a worn outer CV joint. This is usually caused by grease leaking out or dirt penetrating through a damaged CV boot.
Do you offer a fitment guarantee on drivetrain parts?
Yes, when you select your vehicle's make, model and engine and choose a part recommended by our system, we provide a fitment guarantee. It is part of our commitment to ensure you get the right part first time.