Audi A4 Avant 2.0 Tfsi Quattro
Car parts and drivetrain components for Audi A4 Avant 2.0 Tfsi Quattro. Always check the fit before ordering.
Products for Audi A4 Avant 2.0 Tfsi Quattro
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front left
- Flange diameter: 123 mm
- Total length: 595 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 123 mm
- Total length: 620 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 123 mm
- Total length: 495 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 618 mm
- Splines wheel side: 37
- ABS teeth: 45
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 33
- Outer splines: 38
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 25
- Outer splines: 42
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 469 mm
- Splines wheel side: 42
- Position: Rear left
- Total length: 587 mm
- Splines wheel side: 42
- Position: Rear right
- Total length: 545 mm
- Splines wheel side: 42
- Position: Rear left, Rear right
- Flange diameter: 100 mm
- Total length: 626 mm
- Splines wheel side: 42
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,529 mm
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,630 mm
- Position: Rear left, Rear right
- Flange diameter: 100 mm
- Total length: 630 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- Joint diameter: 100 mm
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 33
- Outer splines: 42
- Joint diameter: 88 mm
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,640 mm
Frequently Asked Questions about Drivetrain for Audi A4 Avant 2.0 Tfsi Quattro
How do I know if a CV joint is failing on my Audi A4 Quattro?
The most common signs are a clicking noise on full steering lock (outer CV joint) or vibrations under acceleration (inner CV joint). You should also check whether the CV boot is split.
Do all drive shafts fit the Audi A4 Avant 2.0 Tfsi Quattro?
No, drive shafts vary depending on whether the car has Quattro four-wheel drive, which gearbox is fitted, and the model year. Always filter by your car's make, model and engine to find the correct fit.
Why does my Audi A4 vibrate during acceleration?
Vibrations under acceleration on a Quattro model are frequently caused by worn inner CV joints or an unbalanced propeller shaft. It is vital to rectify this promptly to prevent damage to the gearbox.
Can I replace only the ABS ring on my Audi A4?
Yes, if the CV joint itself is in good condition but the ABS ring is cracked or corroded, you can often replace just the ring to restore proper ABS function.
What is the difference between an inner and an outer CV joint?
The outer CV joint sits closest to the wheel and accommodates steering angles, whereas the inner CV joint is located next to the gearbox and primarily handles suspension movement.
How do I find the correct propeller shaft for my Audi A4 Avant?
The propeller shaft is specific to Quattro models. By selecting your car's exact model, year and engine variant on our website, you will find prop shafts precision-matched to your car's wheelbase and drivetrain.