Audi A4 1.8 T
Car parts and drivetrain components for Audi A4 1.8 T. Always check the fit before ordering.
Products for Audi A4 1.8 T
- Position: Front
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Position: Front right
- Flange diameter: 130 mm
- Total length: 500 mm
- Splines wheel side: 33
- Position: Front left
- Flange diameter: 123 mm
- Total length: 595 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 123 mm
- Total length: 620 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left, Front right
- Flange diameter: 123 mm
- Joint diameter: 123 mm
- Total length: 544 mm
- ABS teeth: 45
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 521 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left
- Flange diameter: 100 mm
- Total length: 615 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 585 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
- Position: Front left
- Flange diameter: 130 mm
- Total length: 523 mm
- Splines wheel side: 33
- Position: Front left
- Flange diameter: 108 mm
- Total length: 609 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front right
- Flange diameter: 108 mm
- Total length: 630 mm
- Splines wheel side: 33
- ABS teeth: 45
- Position: Front right
- Flange diameter: 123 mm
- Total length: 490 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left
- Flange diameter: 100 mm
- Total length: 618 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left
- Flange diameter: 108 mm
- Total length: 616 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 108 mm
- Total length: 638 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Outer
- ABS teeth: 45
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
Frequently Asked Questions about Drivetrain Parts for Audi A4 1.8 T
How do I know if the CV joint on my Audi A4 1.8 T is worn out?
The most common sign is a clicking noise when turning sharply while driving. If the sound disappears when driving straight ahead, it is usually the outer CV joint that is worn.
Can I replace just the ABS ring on my Audi A4 1.8 T?
Yes, if the CV joint itself is in good condition but the ABS ring is cracked or corroded, you can replace just the ring. It is a very cost-effective repair.
Why does my Audi A4 1.8 T vibrate during acceleration?
Vibrations occurring specifically under acceleration are often caused by wear in the inner CV joint. This creates unbalanced play that can be felt throughout the car.
Does the same drive shaft fit both manual and automatic Audi A4 1.8 T models?
No, drive shafts often differ in length and mounting fittings depending on the gearbox. Always select your car's exact model, year and gearbox specification to find the correct version.
What is included when I buy a CV joint from you?
Our CV joint kits are supplied complete with the joint itself, a CV boot, high-quality grease, retaining clips, and any bolts or nuts required for installation.
How often should I inspect the CV boots on my Audi?
We recommend inspecting the CV boots at every oil change or routine service. An intact boot is the best protection against expensive CV joint replacements.