Audi A4 3.0 Tfsi Quattro
Car parts and drivetrain components for Audi A4 3.0 Tfsi Quattro. Always check the fit before ordering.
Products for Audi A4 3.0 Tfsi Quattro
- Position: Front left, Front right
- Total length: 465 mm
- Splines wheel side: 42
- Position: Rear left
- Total length: 587 mm
- Splines wheel side: 42
- Position: Rear right
- Total length: 545 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 28
- Outer splines: 42
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,529 mm
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- ABS teeth: 0
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 466 mm
- Splines wheel side: 42
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Flange diameter: 123 mm
- Total length: 465 mm
- Splines wheel side: 42
- Position: Front, Inner
- Total length: 84 mm
- Splines wheel side: 24
- Position: Front, Inner
- Total length: 88 mm
- Splines gearbox side: 34
- ABS teeth: 34
Frequently asked questions about drivetrain parts for Audi A4 3.0 Tfsi Quattro
How do I know if my Audi A4 3.0 Tfsi Quattro needs a new drive shaft?
The most common signs are vibrations under acceleration or unusual noises when cornering. If you notice steering wheel or seat shudder under load, or hear a clicking sound during sharp turns, you should inspect your drive shafts immediately.
What causes vibrations during acceleration on a Quattro model?
On an Audi A4 3.0 Tfsi Quattro, acceleration vibrations are frequently caused by wear in the inner CV joints. Because the engine produces high torque, these joints wear out more rapidly if the CV boots are split or if the grease has degraded and lost its lubricating properties.
Can I replace just the CV joint, or do I need to replace the complete drive shaft?
That depends on the extent of the damage. If the shaft itself is intact and only the joint is worn, you can replace just the outer or inner CV joint. However, if the shaft bar is damaged or workshop labour makes rebuilding the joint costly, fitting a complete driveshaft is often the more economical and reliable solution.
Does the same drive shaft fit both the right and left side?
No, usually not on the Audi A4 3.0 Tfsi Quattro. Due to the positioning of the gearbox and the Quattro drivetrain layout, the left and right drive shafts typically differ in length and mounting flanges. Always select your specific make, model and engine variant to ensure you order the correct side.
Why is it important to replace a damaged CV boot promptly?
The CV boot protects the constant velocity joint from dirt, water and road grit while keeping the lubricating grease sealed inside. A split boot can cause the joint to fail after just a few dozen kilometres, leading to a far more expensive replacement of the joint or complete shaft.
How does the fitment guarantee work at CVJoint24?
Our fitment guarantee ensures that if you select your vehicle's exact make, model and engine variant and we still send a part that does not fit your Audi A4 3.0 Tfsi Quattro, we will help you exchange it for the correct component at no extra cost. That is our peace-of-mind guarantee to you.