Audi A6 Allroad 3.2 FSI Quattro
Car parts and drivetrain components for Audi A6 Allroad 3.2 FSI Quattro. Always check the fit before ordering.
Products for Audi A6 Allroad 3.2 FSI Quattro
- Position: Front left
- Flange diameter: 123 mm
- Total length: 605 mm
- Splines wheel side: 38
- Position: Front left
- Total length: 617 mm
- Splines wheel side: 38
- Position: Front right
- Flange diameter: 123 mm
- Total length: 525 mm
- Splines wheel side: 38
- Position: Front right
- Flange diameter: 123 mm
- Total length: 655 mm
- Splines wheel side: 38
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,763 mm
- Position: Inner
- ABS teeth: 0
- Inner splines: 28
- Joint diameter: 108 mm
- Outer diameter: 108 mm
- Position: Outer
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- ABS teeth: 0
- Position: Outer
- Inner splines: 33
- Outer diameter: 88 mm
- Splines wheel side: 38
Frequently asked questions about drivetrain parts for Audi A6 Allroad 3.2 FSI Quattro
How do I know if an outer CV joint on my Audi A6 Allroad 3.2 FSI Quattro is worn out?
The most common symptom is a sharp clicking or knocking noise when turning sharply while accelerating. The sound originates from the wheel where the joint is worn.
Why is my Audi A6 Allroad vibrating under acceleration?
Vibrations during acceleration are frequently caused by a worn inner CV joint or an unbalanced propeller shaft. It is essential to inspect these components promptly to avoid secondary damage.
Can I replace just the CV boot instead of the entire CV joint?
Yes, if you detect a split or cracked boot early before grit and water have contaminated and damaged the joint itself, cleaning, repacking with fresh grease and fitting a new CV boot will suffice.
What is the difference between the inner and outer CV joints on this model?
The outer CV joint sits next to the wheel hub and accommodates steering angles, whereas the inner joint connects towards the gearbox and primarily handles vertical suspension travel.
How often does the prop shaft centre bearing need replacing on an Audi A6 Allroad?
There is no fixed replacement interval, but the centre bearing should be inspected if you notice whining noises or vibrations coming from beneath the centre of the car, particularly on higher-mileage vehicles.
Is correct fitment guaranteed when I select my model?
Yes, when you filter by your car's exact make, model and engine variant, we guarantee that the listed parts will fit your specific Audi A6 Allroad 3.2 FSI Quattro perfectly.