Audi A6 1.8 T Quattro
Car parts and drivetrain components for Audi A6 1.8 T Quattro. Always check the fit before ordering.
Products for Audi A6 1.8 T Quattro
- Position: Front left, Front right
- Flange diameter: 123 mm
- Joint diameter: 123 mm
- Total length: 544 mm
- ABS teeth: 45
- Diameter: 30 mm
- Height: 105 mm
- Hole spacing c/c: 241 mm
- Bearing thickness: 15 mm
- Diameter: 30 mm
- Height: 82 mm
- Hole spacing c/c: 241 mm
- Bearing thickness: 13 mm
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 33
- Outer splines: 38
- Position: Outer
- ABS teeth: 45
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,755 mm
- Position: Front
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front right
- Flange diameter: 130 mm
- Total length: 638 mm
- Splines wheel side: 38
- ABS teeth: 45
Frequently Asked Questions about Drivetrain Parts for Audi A6 1.8 T Quattro
How do I know if my Audi A6 1.8 T Quattro needs a new drive shaft?
The most common signs are vibrations under acceleration or clicking noises when cornering. If the CV boot is split and grease has leaked out, the risk increases that the entire shaft will need replacing.
Is it difficult to replace an ABS ring on an Audi A6 Quattro?
It requires removing the CV joint, which can be time-consuming. However, it is a very cost-effective repair compared to replacing the complete CV joint if only the ring is faulty.
Why does my Audi A6 vibrate under acceleration?
Vibrations under acceleration are often caused by worn inner CV joints. On a Quattro model, it can also stem from an unbalanced propeller shaft or a worn centre bearing.
Do your CV joint kits include everything needed for installation?
Yes, our kits for the Audi A6 1.8 T Quattro are supplied complete with the CV joint, CV boot, high-grade grease, clips and, where required, a new centre bolt.
How do the front and rear drive shafts differ on a Quattro?
The front and rear drive shafts differ in length and dimensions to suit the vehicle's chassis geometry and differentials. Always filter by your make, model and engine to ensure you get the correct shaft for the right position.
What does the fitment guarantee mean when I purchase parts for my Audi?
It means that once you select your make, model and engine variant and we confirm the part fits, we guarantee it can be fitted. If against all expectations it does not fit, we handle the return free of charge.