Audi A6 2.0 TDI Quattro
Car parts and drivetrain components for Audi A6 2.0 TDI Quattro. Always check the fit before ordering.
Products for Audi A6 2.0 TDI Quattro
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 495 mm
- Splines wheel side: 42
- Position: Rear right
- Total length: 576 mm
- Splines wheel side: 42
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 660 mm
- Splines wheel side: 42
- Position: Front left
- Flange diameter: 130 mm
- Total length: 488 mm
- Splines wheel side: 42
- Diameter: 30 mm
- Height: 102 mm
- Hole spacing c/c: 228 mm
- Bearing thickness: 15 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,633 mm
- Position: Rear left
- Total length: 620 mm
- Splines wheel side: 42
- Position: Front, Inner
- Total length: 84 mm
- Splines wheel side: 24
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- ABS teeth: 0
- Diameter: 70 mm
- Number of joints: 2
- Total length: 1,529 mm
- Position: Front, Inner
- Total length: 88 mm
- Splines gearbox side: 34
- ABS teeth: 34
Frequently Asked Questions about the Drivetrain for Audi A6 2.0 TDI Quattro
What are the most common signs of a failing drive shaft on my Audi A6 2.0 TDI Quattro?
The most common symptoms are vibrations under acceleration, clunking noises when changing gear, or severe vibrations through the steering wheel. If you hear a clicking sound when cornering, it is usually the outer CV joint that is worn.
Do all Audi A6 drive shafts fit my 2.0 TDI Quattro?
No, drive shafts vary depending on the engine variant, gearbox, and whether the car has Quattro all-wheel drive. Always select your make, model and engine on cvjoint24.com to ensure an exact fit.
How often should I inspect the CV boots on my Audi A6?
We recommend a visual inspection during every service or tyre change. A split CV boot quickly leads to constant velocity joint failure due to dirt ingress and loss of grease.
Can I replace just the CV joint, or do I have to replace the complete drive shaft?
On the Audi A6 2.0 TDI Quattro, you can often replace just the outer CV joint if the shaft itself is undamaged. However, if there are problems with the inner joints, it is often more cost-effective to replace the complete drive shaft.
What causes vibrations from the propeller shaft on a Quattro model?
Vibrations from the propeller shaft are usually caused by a worn centre bearing, imbalance in the shaft itself, or worn joints. This is often felt as a persistent vibration through the vehicle floor or seats at specific speeds.
Is everything I need included when I buy a CV joint kit from you?
Yes, our joint kits are supplied complete with the CV joint, CV boot, grease, clamps, and mounting hardware such as bolts or nuts, allowing you to carry out the replacement straight away.