Audi A7 Sportback 3.0 TDI Quattro
Car parts and drivetrain components for Audi A7 Sportback 3.0 TDI Quattro. Always check the fit before ordering.
Products for Audi A7 Sportback 3.0 TDI Quattro
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 495 mm
- Splines wheel side: 42
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 660 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 28
- Outer splines: 42
- Position: Rear left
- Total length: 620 mm
- Splines wheel side: 42
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,633 mm
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,600 mm
- Position: Rear right
- Total length: 576 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- Joint diameter: 100 mm
- Total length: 498 mm
- Splines wheel side: 42
- ABS teeth: 0
- Diameter: 70 mm
- Number of joints: 2
- Total length: 1,529 mm
- Position: Outer
- Inner splines: 28
- Outer diameter: 99 mm
- Splines wheel side: 42
- Position: Front, Inner
- Total length: 84 mm
- Splines wheel side: 24
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Diameter: 30 mm
- Height: 102 mm
- Hole spacing c/c: 228 mm
- Bearing thickness: 15 mm
- Position: Front, Inner
- Total length: 88 mm
- Splines gearbox side: 34
- ABS teeth: 34
- Position: Front, Outer
- Inner splines: 28
- Outer diameter: 94 mm
- Splines wheel side: 42
- Position: Front, Inner
- Total length: 84 mm
- Splines wheel side: 24
Frequently Asked Questions about Drivetrain for Audi A7 Sportback 3.0 TDI Quattro
How do I know whether the inner or outer CV joint is faulty on my Audi A7?
A faulty outer CV joint usually produces a clicking noise at full steering lock while driving. A worn inner CV joint tends to cause vibrations through the car's body under acceleration, which typically vanish as soon as you ease off the accelerator.
Do all Audi A7 Sportback drive shafts fit the 3.0 TDI Quattro?
No, drive shafts differ depending on the engine option, gearbox (e.g. S-tronic) and whether the car is equipped with Quattro four-wheel drive. Always select your car's exact make, model and engine to ensure you receive the correct part for your specific variant.
Why does my Audi A7 Sportback 3.0 TDI vibrate at higher speeds?
Persistent vibrations at higher speeds are frequently caused by an unbalanced propeller shaft or a worn centre bearing. Wheel imbalance can also be the culprit, but if the vibrations are felt throughout the entire car, the prop shaft is a likely cause.
Do your CV joint kits include everything needed for the replacement?
Yes, our CV joint kits come complete with the CV joint, CV boot, grease, clamps and fitting hardware such as a bolt or nut, ensuring you have everything required for a proper installation.
How often should I inspect the CV boots on my Audi A7?
We recommend inspecting the CV boots at every routine service or seasonal tyre change. A split CV boot is the most common reason for premature constant velocity joint failure, as grease escapes and road dirt gets inside.
Do you offer a fitment guarantee on parts for the Audi A7 Sportback 3.0 TDI Quattro?
Yes, we offer a fitment guarantee whenever you select your car by make, model and engine variant in our shop. This guarantees that the part will fit your vehicle according to the specifications in our database.