Audi TT 2.0 TDI Quattro
Car parts and drivetrain components for Audi TT 2.0 TDI Quattro. Always check the fit before ordering.
Products for Audi TT 2.0 TDI Quattro
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 36
- Joint diameter: 97,95 mm
- Position: Front left
- Flange diameter: 119 mm
- Total length: 475 mm
- Splines wheel side: 36
- Position: Rear left
- Flange diameter: 100 mm
- Total length: 610 mm
- Splines wheel side: 36
- Position: Rear right
- Total length: 653 mm
- Splines wheel side: 36
- Position: Rear, Inner
- Diameter: 86 mm
- Splines gearbox side: 33
- Width: 34 mm
- Position: Rear, Outer
- Seal diameter: 59 mm
- Inner splines: 33
- Outer diameter: 82 mm
- Splines wheel side: 36
- Position: Front right
- Flange diameter: 119 mm
- Total length: 586 mm
- Splines wheel side: 36
- ABS teeth: 0
- Position: Front left
- Flange diameter: 108 mm
- Joint diameter: 108 mm
- Total length: 495 mm
- Splines wheel side: 36
- Position: Outer
- Seal diameter: 60 mm
- Inner splines: 30
- Outer splines: 36
- ABS teeth: 0
- Number of centre bearings: 1
- Number of joints: 1
- Total length: 2,160 mm
- Position: Front right
- Flange diameter: 108 mm
- Total length: 615 mm
- Splines wheel side: 36
- Position: Front right
- Flange diameter: 119 mm
- Total length: 760 mm
- Splines wheel side: 36
- Position: Front right
- Flange diameter: 108 mm
- Total length: 806 mm
- Splines gearbox side: 108
- ABS teeth: 0
- Position: Rear left
- Diameter: 94 mm
- Flange diameter: 94 mm
- Total length: 611 mm
- ABS teeth: 0
- Position: Rear right
- Diameter: 83 mm
- Flange diameter: 94 mm
- Total length: 650 mm
- ABS teeth: 0
- Position: Inner
- Seal diameter: 94 mm
- Inner splines: 33
- Number of joints: 3
- ABS teeth: 0
- Position: Outer
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 36
- Joint diameter: 97,95 mm
- Position: Rear, Outer
- Seal diameter: 59,5 mm
- Inner splines: 33
- Total length: 80 mm
- Splines gearbox side: 36
- Position: Outer
- Inner splines: 27
- Outer diameter: 98 mm
- Splines wheel side: 36
- ABS teeth: 0
Frequently Asked Questions about Drivetrain for Audi TT 2.0 TDI Quattro
How do I know if my Audi TT 2.0 TDI Quattro needs a new drive shaft?
The most common signs are heavy vibrations through the car during acceleration or unusual noises coming from underneath. Because the Quattro system distributes power to all four wheels, these vibrations can feel noticeably different compared to a front-wheel-drive car.
Is there a difference in CV joints between Quattro and front-wheel-drive Audi TT models?
Yes, there are often major differences in dimensions, splines and mountings between Quattro models and front-wheel-drive variants. Always select your vehicle's exact make, model and engine to ensure the correct fitment.
What happens if a CV boot splits on my Audi TT?
If a CV boot tears, lubricating grease leaks out and abrasive dirt enters the CV joint. This rapidly accelerates wear and eventually leads to complete failure. Replacing the CV boot immediately is essential to save the constant velocity joint.
Can I replace just the CV joint, or do I have to replace the complete drive shaft?
On the Audi TT 2.0 TDI Quattro, you can often replace just the CV joint if the shaft itself is undamaged. We supply both individual CV joints and complete drive shafts, allowing you to choose the most cost-effective option for your repair.
How does the fitment guarantee work at CVJoint24?
Our fitment guarantee means that when you select your vehicle by make, model and engine and order the recommended part, we guarantee it will fit your car mechanically.
Why do inner CV joints wear faster on TDI models?
Diesel engines such as the 2.0 TDI produce substantial torque at low revs. This places high physical stress on the inner CV joints under acceleration, which can cause them to wear faster than on petrol models.