BMW 7 Serie 730 LD
Car parts and drivetrain components for BMW 7 Serie 730 LD. Always check the fit before ordering.
Products for BMW 7 Serie 730 LD
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,703 mm
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Position: Rear right
- Flange diameter: 108 mm
- Total length: 651 mm
- Splines wheel side: 30
- Position: Rear right
- Flange diameter: 108 mm
- Total length: 653 mm
- Splines wheel side: 30
Frequently asked questions about drivetrain parts for BMW 7 Serie 730 LD
How do I know if my BMW 730 LD needs a new drive shaft?
The most common signs are vibrations under acceleration or clicking noises when cornering. If you notice that vibrations increase with speed or load, you should inspect the drive shafts immediately.
Can I replace just the centre bearing, or does the entire propeller shaft need replacing?
It is often possible to replace just the centre bearing if the prop shaft itself is in good condition and properly balanced. This is a cost-effective solution for eliminating vibrations originating from the centre section of the car.
Do your parts fit both rear-wheel drive and xDrive models?
We supply parts for both drivetrains. Because drive shafts and propeller shafts differ between rear-wheel drive and all-wheel drive, it is important that you select your car's exact make, model and engine variant to find the correct parts.
What does the fitment guarantee mean for my BMW 7 Series?
Our fitment guarantee means that when you select your specific model and engine and order the recommended part, we guarantee that it will fit. In the unlikely event that something does not match, we will help you find the correct part right away.
How quickly are parts delivered for my BMW 730 LD?
We offer fast delivery across Europe from our Swedish central warehouse for most in-stock products. We understand how important your BMW is to your daily life and aim to keep downtime to an absolute minimum.
Are your drive shafts complete with CV joints and boots?
Yes, our drive shafts are supplied as complete units ready for installation, which includes both the inner and outer CV joints as well as pre-fitted CV boots filled with grease.