BMW 7 Serie
Car parts and drivetrain components for BMW 7 Serie.
Products for BMW 7 Serie
- Diameter: 35 mm
- Hole spacing c/c: 160 mm
- Bearing thickness: 28 mm
- Position: Rear
- Total length: 646 mm
- Splines wheel side: 30
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,703 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,845 mm
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,699 mm
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 2
- Total length: 1,836 mm
- Position: Rear right
- Flange diameter: 108 mm
- Total length: 651 mm
- Splines wheel side: 30
- Position: Rear right
- Total length: 826 mm
- Splines gearbox side: 32
- Splines wheel side: 30
- Position: Outer
- Seal diameter: 65 mm
- Inner splines: 25
- Outer splines: 37
- Position: Front right, Inner
- Seal diameter: 44 mm
- Inner splines: 24
- Total length: 485 mm
- ABS teeth: 24
- Position: Front left
- Total length: 575 mm
- Splines gearbox side: 27
- Splines wheel side: 37
- Position: Front right
- Total length: 879 mm
- Splines gearbox side: 27
- Splines wheel side: 37
Frequently Asked Questions about Drivetrain for BMW 7 Series - Spare Parts with a Perfect Fit
How do I know if the vibrations in my BMW 7 Series are coming from the propeller shaft?
Vibrations from the propeller shaft are often felt throughout the entire bodywork and vary with the vehicle's speed rather than engine revs. They typically appear at higher speeds, such as 80–120 km/h, and can indicate an imbalance or a worn centre bearing.
Does the same drive shaft fit both rear-wheel drive and xDrive models?
No, drive shafts differ between rear-wheel drive and all-wheel drive (xDrive) versions. Furthermore, xDrive models have front drive shafts that do not exist on rear-wheel drive models. Always select your car's make, model and engine to find the correct part.
What causes a clicking sound on full steering lock on my 7 Series?
This is a classic symptom of a worn outer CV joint. It is most often caused by a split CV boot, which has allowed grease to leak out and dirt to enter the joint, leading to mechanical wear.
How many propeller shafts do you offer for the BMW 7 Series?
We have an extensive range featuring 102 different propeller shafts for the BMW 7 Series, covering a wide variety of engine options, gearboxes and wheelbases.
Can I replace just the inner CV joint, or do I have to replace the complete drive shaft?
On many BMW 7 Series models, it is possible to replace only the inner CV joint if the shaft itself is otherwise undamaged. We offer 4 specific inner constant velocity joints to enable a more cost-effective repair.
Why is the correct grease so important for the CV joints on a BMW 7 Series?
The BMW 7 Series delivers substantial torque and carries heavy loads. The right high-performance grease is crucial for minimising friction and heat build-up inside the CV joint, significantly extending its service life.
Do your drive shafts include ABS rings?
Yes, where the ABS ring is fitted directly to the drive shaft or joint for your specific BMW 7 Series model, it is included or prepared for installation in accordance with original specifications.