Drive shafts for Volvo V70 2.4 Turbo AWD

For your Volvo V70 2.4 Turbo AWD estate, we supply premium drive shafts tailored to the demands of four-wheel drive. Easily identify the correct component for your car by selecting your...

Products for Drive shafts for Volvo V70 2.4 Turbo AWD

25 products
1 - 24 of 25
Item no.:514243
  • Position: Rear
  • Total length: 752 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
  • ABS teeth: 48
Item no.:1134248
  • Position: Front left
  • Total length: 580 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
Item no.:1124068
  • Position: Front left
  • Total length: 540 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:1196819
  • Position: Front left
  • Total length: 525 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:2156667
  • Position: Front right
  • Total length: 1,025 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
Item no.:2190414
  • Position: Front right
  • Total length: 1,025 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
  • ABS teeth: 48
Item no.:1121736
  • Position: Front left
  • Total length: 580 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
  • ABS teeth: 48
Item no.:2128622
  • Position: Front right
  • Total length: 977 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:2127914
  • Position: Front right
  • Total length: 971 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:1179128
  • Position: Front left
  • Total length: 505 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:211330
  • Position: Front right
  • Total length: 947 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Item no.:117165
  • Total length: 506 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:216333
  • Total length: 970 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Item no.:0191234
  • Total length: 630 mm
  • Splines wheel side: 25
Item no.:211295
  • Total length: 1,002 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Item no.:116204
  • Total length: 574,5 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
  • ABS teeth: 48
Item no.:2105021
  • Total length: 1,028 mm
  • Splines gearbox side: 26
  • Splines wheel side: 26
  • ABS teeth: 48
Item no.:2112742
  • Total length: 977 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:1176998
  • Position: Front left
  • Total length: 526 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:116805
  • Total length: 525 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Item no.:110617
  • Position: Front left
  • Total length: 522 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
  • ABS teeth: 48
Item no.:112121
  • Total length: 535 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Item no.:110745
  • Total length: 575 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Item no.:112504
  • Total length: 525 mm
  • Splines gearbox side: 26
  • Splines wheel side: 36
Showing 1–24 of 25 products

Drive shafts for Volvo V70 2.4 Turbo AWD

Owning a Volvo V70 2.4 Turbo AWD means driving a high-performance vehicle with an advanced all-wheel drive system. To maintain the car's handling and safety, it is vital that every drive shaft is in peak condition. The drive shafts on an AWD model face unique stresses compared to front-wheel drive variants, as they have to cope with power distribution across both axles under varying road conditions. We offer a carefully selected range of drive shafts engineered specifically to meet the technical demands of the 2.4 Turbo engine and its accompanying drivetrain.

Our products are developed to provide the same precision and durability as original components, but at a more competitive price. With 11 matching items in our system, we cater to the varied requirements that arise across different model years and specific configurations. Choosing the correct components ensures your car's four-wheel drive operates seamlessly and that power from the turbo engine reaches the road without losses or disturbing noises.

What does a drive shaft do on a Volvo V70 2.4 Turbo AWD?

The drive shaft is a critical link in the vehicle's power delivery. Its main task is to transmit torque from the gearbox and differential out to the wheels, whilst accommodating suspension travel and steering angles. On a Volvo V70 2.4 Turbo AWD, this layout is more complex than on a standard car. Power travels from the engine through the gearbox to an angle gear, which then distributes torque to the front drive shafts and through the propeller shaft towards the rear wheels.

The front driveshafts must handle both the generous output of the 2.4-litre turbo engine and the articulation angles generated by steering. The inner and outer CV joints on the shaft work in tandem to ensure smooth power transfer regardless of wheel position. If a drive shaft fails, it does not merely affect drive to that particular wheel; it can also place undue stress on the car's Haldex coupling or differentials. Replacing a worn shaft promptly is a sensible investment in your car's overall service life.

Common signs of wear

Several distinct symptoms indicate that a drive shaft on your Volvo V70 2.4 Turbo AWD is deteriorating. One of the most frequent signs is a clicking or knocking noise when taking sharp turns at low speeds. This typically points to an outer CV joint that is worn or contaminated with dirt following a split CV boot. If the noise subsides when driving straight ahead but returns upon cornering, this strongly suggests the component requires replacement.

Another common symptom is vibration through the car body under acceleration. This is often caused by wear in the inner constant velocity joint, creating an imbalance in the driveshaft under load from the turbo engine. You should also inspect the CV joint boots regularly; if they are cracked, grease escapes and grit enters, rapidly ruining the precision-machined bearing surfaces within the joint. Ignoring these early warnings can eventually lead to complete failure, leaving the car immobilised.

How to choose the correct drive shaft

Selecting the right drive shaft for a Volvo V70 2.4 Turbo AWD requires care, as specifications vary between production years and trim levels. The most important step is to filter by your car's exact make, model and engine variant in our shop catalogue. This narrows down the parts that are guaranteed to fit your vehicle. Parameters such as total shaft length, spline counts at both ends, and the specific ABS setup are decisive factors for an accurate installation.

Always verify whether there are differences between the left and right sides, as these shafts are rarely identical on AWD configurations. Many shafts are supplied complete with pre-fitted CV joints and boots, which is often the most cost-effective solution because it saves time in the garage and ensures all related components are brand new. By comparing your technical details against our product specifications, you avoid incorrect orders and restore your Volvo to full reliability straight away.

Related parts to inspect

We recommend checking these exact pages for the same vehicle when working on the drive shaft:

When one drivetrain component shows signs of wear, nearby parts on the vehicle often warrant inspection too. By comparing these exact pages for the Volvo V70 2.4 Turbo AWD, it is easier to confirm whether the problem lies with the drive shaft itself or another adjacent section of the driveline.

This is especially important on AWD models where vibrations, play and strange noises can transfer between several components in the system. A quick check of related categories reduces the risk of replacing one correct part while overlooking an adjacent component contributing to the same issue.

By inspecting the complete system at the same time, you reduce the risk of future breakdowns and ensure your all-wheel drive works exactly as intended by the factory. Replacing worn minor parts during a major job saves both time and money over the long term.

Why shop at CVJoint24?

CVJoint24 is the international shop of a Swedish driveline specialist, with our central warehouse based in Helsingborg, Sweden. We understand the technical specifics of the Volvo V70 2.4 Turbo AWD and have assembled an inventory centred on quality and precise fitment. When you buy from us, you receive high-quality car parts supported by our fitment guarantee. Getting the right part first time is just as crucial for home DIY mechanics as it is for professional garages, which is why we continually refine our vehicle database.

We dispatch our own stocked parts across the EU, minimising downtime while your car is on axle stands. As a customer, you can always rely on receiving the right spare parts at a fair price, backed by genuine specialist expertise. Our goal is to be the obvious choice for anyone who expects the best for their vehicle's drivetrain and wants a straightforward purchasing experience from search to delivery.

Frequently asked questions about drive shafts for Volvo V70 2.4 Turbo AWD

Does the same drive shaft fit both the front and rear wheels on my V70 AWD?

No, the front and rear drive shafts differ significantly in both length and design. Furthermore, there is often a difference between the front left and front right sides due to the position of the gearbox.

How do I know whether the drive shaft or the propeller shaft is causing vibrations?

Vibrations from a drive shaft are usually felt most clearly under acceleration and can vary depending on steering angle. Vibrations from the propeller shaft are typically more constant at specific speeds, regardless of acceleration.

Is an ABS ring included when I buy a complete drive shaft for my Volvo V70?

Yes, on most complete drive shafts for Volvo V70 2.4 Turbo AWD, the ABS ring is already pre-fitted. Always check the product specification to be completely sure.

Can I replace the drive shaft myself on my Volvo V70 2.4 Turbo AWD?

Yes, it is entirely feasible for a capable DIY mechanic with the right tools, but it requires undoing the hub nut and, in some cases, parts of the suspension. Remember to check the gearbox oil level afterwards.

Why is having the correct number of splines on the drive shaft important?

Splines are the teeth that lock the shaft into the wheel hub and the gearbox. If the tooth count does not match exactly, the shaft cannot be fitted, or it risks damaging the splines in your car's mating components.

How often should I check the boots on my drive shafts?

We recommend a visual inspection at every service or seasonal tyre change. An intact CV boot is the best protection against premature drive shaft failure.