Ford Focus III Turnier

Spare parts and drivetrain components for Ford Focus III Turnier.

Products for Ford Focus III Turnier

73 products
49 - 72 of 73
Item no.:3559130
  • Position: Outer
  • Inner splines: 23
  • Splines wheel side: 36
  • Seal diameter: 56 mm
  • Outer diameter: 82 mm
Item no.:256139
  • Position: Outer
  • Inner splines: 24
  • Seal diameter: 56 mm
  • Outer splines: 36
  • Thread size: M10
Item no.:0659200
  • Total length: 85 mm
Item no.:244625
  • Position: Front right, Inner
  • Inner splines: 23
  • Splines gearbox side: 26
  • Seal diameter: 40 mm
  • Outer diameter: 79 mm
Item no.:397334
  • Position: Front
Item no.:146510
  • Position: Front left, Inner
  • Inner splines: 24
  • Splines gearbox side: 26
  • Seal diameter: 40 mm
  • Total length: 172 mm
Item no.:0597527
  • Position: Front, Outer
  • Inner splines: 23
  • Splines wheel side: 27
  • Outer diameter: 82 mm
Item no.:142460
  • Position: Front left, Inner
  • Inner splines: 26
  • Splines gearbox side: 28
  • Seal diameter: 34 mm
  • Total length: 170,5 mm
Item no.:0587267
  • Position: Outer
  • Inner splines: 20
  • Seal diameter: 47 mm
  • Outer splines: 22
  • Thread size: M22X1,5
Item no.:243590
  • Position: Front right, Inner
  • Inner splines: 26
  • Splines gearbox side: 28
  • Seal diameter: 33,8 mm
  • Total length: 486,5 mm
Item no.:350584
  • Position: Front, Outer
  • Inner splines: 33
  • Splines wheel side: 33
  • Seal diameter: 62,8 mm
  • Thread size: 27
Item no.:0688611
  • Total length: 94 mm
Item no.:3519009
  • Position: Front, Outer
  • Inner splines: 26
  • Seal diameter: 56 mm
  • Outer splines: 36
  • Thread size: M10X1,5
Item no.:149964
  • Position: Front left, Inner
  • Inner splines: 32
  • Splines gearbox side: 26
  • Seal diameter: 40 mm
  • Outer diameter: 83 mm
Item no.:191577
  • Position: Front left
  • Splines gearbox side: 26
  • Splines wheel side: 32
Item no.:1143925
  • Splines gearbox side: 34
  • Splines wheel side: 25
  • Total length: 564 mm
  • Joint diameter: 77 mm
  • Joint diameter, gearbox side: 79 mm
Item no.:2153876
  • Splines gearbox side: 34
  • Splines wheel side: 25
  • Total length: 969 mm
  • Joint diameter: 77 mm
  • Joint diameter, gearbox side: 79 mm
Item no.:0578628
  • Position: Outer
  • Inner splines: 33
  • Splines wheel side: 27
  • Outer diameter: 82 mm
Item no.:3538614
  • Position: Outer
  • Inner splines: 26
  • Splines wheel side: 27
  • Outer diameter: 91 mm
Item no.:246572
  • Position: Front right, Inner
  • Inner splines: 24
  • Splines gearbox side: 26
  • Seal diameter: 40 mm
  • Total length: 546 mm
Item no.:154197
  • Position: Front left, Outer
  • Inner splines: 26
  • Splines wheel side: 27
  • Seal diameter: 63 mm
  • Thread size: M22X1,5
Item no.:358355
  • Position: Front, Outer
  • Inner splines: 24
  • Splines wheel side: 27
  • Seal diameter: 60,8 mm
  • Thread size: M22X1,5
Item no.:148620
  • Position: Front left, Inner
  • Inner splines: 23
  • Seal diameter: 40 mm
  • Joint diameter: 76 mm
  • Outer splines: 26
Item no.:242673
  • Position: Front right, Inner
  • Inner splines: 23
  • Seal diameter: 40 mm
  • Total length: 480 mm
  • Joint diameter: 76 mm
Showing 49–72 of 73 products

Drivetrain for Ford Focus III Turnier

The drivetrain on a Ford Focus III Turnier is a sophisticated design that requires precision and high-quality components to maintain the car's renowned driving dynamics. As a driveline specialist, we understand the importance of every part, from the gearbox out to the wheel hub, working in perfect harmony. The Ford Focus III Turnier is a popular family estate that is frequently subjected to varying loads, placing high demands on a robust and reliable power transmission. We have assembled a range tailored specifically to this model so that you, as the owner, can find the right spare parts without hassle.

By focusing on quality and an exact fit, we help you extend the lifespan of your car. Our selection for Ford Focus III Turnier covers a broad range of specific items, demonstrating our deep coverage for this model series. Maintaining the drivetrain is not only a matter of operational reliability, but also of fuel economy and ride comfort. A worn drivetrain can cause unnecessary friction and vibrations that ultimately harm other parts of the vehicle.

How the drivetrain is engineered on Ford Focus III Turnier

The Ford Focus III Turnier uses a front-wheel-drive configuration with a transverse engine. Power is transmitted from the gearbox via two drive shafts of differing lengths to the front wheels. This setup requires the drive shafts to cope with suspension movements and steering angles simultaneously while transmitting torque. Each driveshaft is equipped with two joints: an inner CV joint mounted at the gearbox and an outer CV joint located at the wheel. The outer joint is particularly critical, as it must accommodate wide angles when cornering.

The CV joints are protected by rubber CV boots that retain the lubricating grease and seal out dirt and water. On Ford Focus III Turnier, these components are dimensioned to strike an ideal balance between weight and strength. Because the model is available with various engine options, from economical diesels to spirited petrol units, the specifications of the drive shafts vary slightly according to torque output. It is therefore crucial to select parts precisely tailored to your car's exact configuration.

Common faults and symptoms

There are several clear signs that the drivetrain on your Ford Focus III Turnier is beginning to wear. One of the most common symptoms is a clicking or knocking noise heard on full steering lock under acceleration. This typically indicates that an outer CV joint for Ford Focus III Turnier is starting to fail, often because a boot has split and let in contaminants. If you instead experience vibrations throughout the car under acceleration, it may be a sign that the inner constant velocity joints are worn.

Another symptom to watch out for is oil or grease spots on the inside of the wheel rim or on the ground where you parked. This points to a leaking CV joint boot. If the fault is caught early, replacing the boot and repacking the joint with grease may be sufficient, but driving too long with a split boot inevitably causes terminal damage to the joint. Vibrations at higher speeds can also stem from an unbalanced or damaged drive shaft on a Ford Focus III Turnier, which should be dealt with promptly to prevent consequential damage to gearbox bearings.

Common parts to replace on Ford Focus III Turnier

Within the drivetrain category for Ford Focus III Turnier, drive shafts and outer CV joints are the parts most frequently replaced. We currently offer several different complete drive shaft options, covering most engine and gearbox combinations for this model. Replacing a complete driveshaft is often a cost-effective solution, as you receive both inner and outer joints as well as new CV boots in a single unit, minimising the risk of future problems.

Where only the outer section is damaged, we provide multiple specific options for outer CV joints. These are precision-engineered components designed to handle the stresses of spirited driving and city traffic. In addition to these main components, it is also common to need replacement ABS rings if the originals have corroded or cracked, which triggers fault codes in the vehicle safety systems. Choosing the right car parts ensures your Ford Focus III Turnier retains its safety and performance.

How to find the right part for Ford Focus III Turnier

Proceed to the relevant subcategory for Ford Focus III Turnier:

On a model with multiple possible drivetrain issues, it is wise to start in the right category right away. Comparing the specific subcategories for Ford Focus III Turnier makes it easier to distinguish between faults in a drive shaft, CV joint or propeller shaft, and to proceed to the page that best matches your symptoms and fitment.

Identifying the exact part that fits your Ford Focus III Turnier can sometimes be challenging, as variations exist depending on model year, engine size and gearbox type. The most effective way to ensure correct fitment is to select your car's make, model and engine from our catalogue. Filtering by vehicle specification ensures you only view parts compatible with your specific car, eliminating guesswork and preventing incorrect orders.

To assist you further, we have divided our range into clear subcategories. You can navigate directly to what you need using the links below:

  • Drive shafts for Ford Focus III Turnier
  • Outer CV joints for Ford Focus III Turnier
If you are uncertain whether you require an entire shaft or just a joint, we recommend inspecting the underside of the vehicle to check the condition of the boots and look for any play in the joints.

Why shop at cvjoint24.com

CVJoint24 is your dedicated partner for driveline and power transmission components. As a Swedish driveline specialist, we have established unique technical expertise and a product catalogue with depth that few can match. We understand the technical nuances of every component and impose rigorous standards on our suppliers so you receive car parts that truly perform. Our sole focus on driveline systems enables us to provide advice and technical support that general motor factors simply cannot offer.

Shopping with us not only gives you access to premium spare parts, but also the assurance that we understand your car's exact needs. With our straightforward vehicle selector, prompt dispatch from our Swedish warehouse across the EU, and relentless focus on accurate fitment, we make buying replacement parts as straightforward and reliable as possible. We are dedicated to keeping European vehicles on the road with safe, efficient drivetrains, whether you are a DIY mechanic or a professional garage.

Frequently Asked Questions about Drivetrain Parts for Ford Focus III Turnier

How do I know if my Ford Focus III Turnier needs a new drive shaft?

The most common signs are vibrations under acceleration or unusual noises while driving. If you notice the car shaking when you accelerate, but the shudder stops when you ease off the throttle, the inner CV joint on the drive shaft is often worn.

Why is there a clicking noise when I turn in my Ford Focus?

A clicking sound on full lock is almost always caused by a worn outer CV joint. This typically happens when a CV boot has split, allowing the grease to leak out and dirt to enter the joint.

How do I find the right parts for my car?

Simply select your car's make, model and engine variant in our search filter to ensure you get the exact drive shaft or CV joint required for your specific Ford Focus III Turnier.

Is it better to replace the complete drive shaft or just the CV joint?

It depends on the condition of the assembly. Replacing the complete drive shaft is often easier and provides a more durable long-term solution, as you get new joints and CV boots at both ends, minimising the risk of future problems.

What drivetrain brands do you offer for Ford?

As drivetrain specialists, we provide carefully selected components that meet or exceed original equipment specifications for the Ford Focus III Turnier, guaranteeing the best possible fit and durability.

How many drive shafts for the Ford Focus III Turnier do you stock?

We currently stock 21 different drive shafts tailored for the Ford Focus III Turnier, covering a wide range of engines and gearboxes for this model.