Volkswagen Passat 3.2 FSI 4MOTION

Car parts and drivetrain components for Volkswagen Passat 3.2 FSI 4MOTION. Always check the fit before ordering.

Products for Volkswagen Passat 3.2 FSI 4MOTION

26 products
1 - 24 of 26
Item no.:2102599
  • Position: Front right
  • Flange diameter: 119 mm
  • Total length: 586 mm
  • Splines wheel side: 36
Item no.:0497585
  • Position: Inner
  • Inner splines: 28
  • Joint diameter: 108 mm
Item no.:0470390
  • Position: Inner
  • Seal diameter: 100 mm
  • Inner splines: 33
  • Joint diameter: 100 mm
Item no.:0468196
  • Position: Inner
  • Inner splines: 34
  • Outer splines: 40
Item no.:0420165
  • Position: Inner
  • Inner splines: 32
  • Outer splines: 119
Item no.:0507204
  • Position: Outer
  • Seal diameter: 60 mm
  • Inner splines: 30
  • Outer splines: 36
  • Joint diameter: 89,9 mm
Item no.:0552025
  • Position: Outer
  • Seal diameter: 59 mm
  • Inner splines: 27
  • Outer splines: 36
  • Joint diameter: 97,95 mm
Item no.:0253220
  • Number of centre bearings: 1
  • Number of joints: 1
  • Total length: 2,160 mm
Item no.:1158362
  • Position: Front left
  • Flange diameter: 108 mm
  • Total length: 488 mm
  • Splines wheel side: 36
Item no.:1127886
  • Position: Front left
  • Flange diameter: 119 mm
  • Total length: 475 mm
  • Splines wheel side: 36
Item no.:1182478
  • Position: Front left
  • Flange diameter: 108 mm
  • Total length: 486 mm
  • Splines wheel side: 36
Item no.:2189117
  • Position: Front right
  • Total length: 800 mm
  • Splines gearbox side: 23
  • Splines wheel side: 36
Item no.:2162793
  • Position: Front right
  • Flange diameter: 108 mm
  • Total length: 600 mm
  • Splines wheel side: 36
Item no.:4167608
  • Position: Rear left
  • Flange diameter: 100 mm
  • Total length: 594 mm
  • Splines wheel side: 36
Item no.:5140489
  • Position: Rear right
  • Flange diameter: 100 mm
  • Total length: 631 mm
  • Splines wheel side: 36
Item no.:144124
  • Position: Front left, Inner
  • Seal diameter: 31 mm
  • Inner splines: 34
  • Outer diameter: 85 mm
  • Splines gearbox side: 26
Item no.:645605
  • Position: Rear, Inner
  • Diameter: 86 mm
  • Splines gearbox side: 33
  • Width: 34 mm
Item no.:650108
  • Position: Rear, Outer
  • Seal diameter: 59 mm
  • Inner splines: 33
  • Outer diameter: 82 mm
  • Splines wheel side: 36
Item no.:348154
  • Position: Inner
  • Seal diameter: 130 mm
  • Inner splines: 34
Item no.:0693149
  • Height: 85 mm
  • Inner diameter: 22 mm
  • Outer diameter: 80 mm
Item no.:215918
  • Flange diameter: 119 mm
  • Total length: 590 mm
  • Splines wheel side: 36
Item no.:341908
  • Position: Inner
  • Inner splines: 28
Item no.:0455810
  • Position: Inner
  • Seal diameter: 94 mm
  • Inner splines: 33
  • Number of joints: 3
  • ABS teeth: 0
Showing 1–24 of 26 products

Frequently Asked Questions about Drivetrain Parts for Volkswagen Passat 3.2 FSI 4MOTION

How do I know if the drive shaft on my Passat 3.2 FSI 4MOTION needs replacing?

The most common signs are vibrations during acceleration or knocking noises when turning. If you notice an imbalance in the car that worsens with speed, you should inspect both the drive shafts and the propeller shaft.

Does the same CV joint fit all Volkswagen Passat models?

No, the 3.2 FSI 4MOTION uses specific CV joints engineered to handle higher torque and the demands of all-wheel drive. Always select your car's make, model and engine to find the correct part.

What is the difference between the inner and outer CV joint on my Passat?

The outer CV joint sits at the wheel hub and allows for steering, whilst the inner joint sits at the gearbox or differential and primarily accommodates suspension movement and power delivery.

Why does my Passat 3.2 FSI vibrate under hard acceleration?

This is often caused by wear in the inner CV joints. On 4MOTION models, it can also be due to an imbalance in the propeller shaft or a worn centre bearing.

Are the CV boot and grease included when I buy a CV joint from you?

Yes, our CV joints are supplied as complete kits including the CV boot, grease, clamps and fitting hardware to ensure a straightforward and proper replacement.

How often should I inspect the propeller shaft on my 4MOTION?

We recommend a visual inspection at every service. Pay close attention to cracks in rubber mountings or play in the centre bearing to avoid more serious driveline failures.