Audi A6 Avant 2.8 FSI Quattro
Car parts and drivetrain components for Audi A6 Avant 2.8 FSI Quattro. Always check the fit before ordering.
Products for Audi A6 Avant 2.8 FSI Quattro
- Position: Front left
- Flange diameter: 123 mm
- Total length: 605 mm
- Splines wheel side: 38
- Position: Front right
- Flange diameter: 123 mm
- Total length: 525 mm
- Splines wheel side: 38
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 650 mm
- Splines wheel side: 38
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,763 mm
- Position: Outer
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Joint diameter: 100 mm
- Position: Front left
- Total length: 617 mm
- Splines wheel side: 38
- Position: Front right
- Flange diameter: 123 mm
- Total length: 655 mm
- Splines wheel side: 38
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 495 mm
- Splines wheel side: 42
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 660 mm
- Splines wheel side: 42
- Diameter: 30 mm
- Height: 102 mm
- Hole spacing c/c: 228 mm
- Bearing thickness: 15 mm
- Position: Outer
- Seal diameter: 76,5 mm
- Inner splines: 29
- Outer splines: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 28
- Outer splines: 42
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,633 mm
- Position: Rear left
- Total length: 620 mm
- Splines wheel side: 42
- Position: Outer
- Inner splines: 28
- Outer diameter: 99 mm
- Splines wheel side: 42
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- ABS teeth: 0
- Diameter: 70 mm
- Number of joints: 2
- Total length: 1,529 mm
- Position: Front right
- Diameter: 104 mm
- Total length: 588 mm
- Splines wheel side: 38
Frequently asked questions about drivetrain parts for Audi A6 Avant 2.8 FSI Quattro
How do I know if my Audi A6 Avant 2.8 FSI Quattro needs a new drive shaft?
The most common signs are vibrations under acceleration or unusual noises when cornering. If you notice that the CV boot is torn and grease has escaped, there is a strong risk that the shaft or CV joint must be replaced.
What symptoms indicate a worn propeller shaft on this model?
A worn propeller shaft frequently causes vibrations felt throughout the whole car, particularly at specific speeds. You may also hear a whining or clunking noise coming from underneath the centre of the vehicle.
Do all Audi A6 parts fit my 2.8 FSI Quattro?
No, Quattro models often require specific drive shafts and joints compared to front-wheel-drive models. Always select your car's make, model and engine to ensure the correct fitment.
Why is it important to replace a damaged CV boot promptly?
The CV boot protects the constant velocity joint against dirt and water ingress. If it splits, the grease escapes and the joint will wear out very quickly, resulting in a far more expensive repair.
What is the difference between an inner and an outer CV joint?
The outer CV joint is located by the wheel hub and accommodates steering angles, whereas the inner joint sits by the gearbox and absorbs changes in shaft length as the suspension travels up and down.
How quickly can I receive spare parts for my Audi?
We dispatch quickly across Europe from our central Swedish warehouse, ensuring you receive your replacement parts promptly to get your Audi A6 Avant 2.8 FSI Quattro back on the road.