Audi A6 Avant 2.8 Quattro
Car parts and drivetrain components for Audi A6 Avant 2.8 Quattro. Always check the fit before ordering.
Products for Audi A6 Avant 2.8 Quattro
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Front right
- Flange diameter: 108 mm
- Total length: 662 mm
- Splines wheel side: 38
- ABS teeth: 45
- Diameter: 30 mm
- Height: 69 mm
- Hole spacing c/c: 178 mm
- Bearing thickness: 16 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Position: Front right
- Flange diameter: 130 mm
- Total length: 550 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left
- Flange diameter: 130 mm
- Total length: 625 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 524 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 643 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left, Front right
- Flange diameter: 123 mm
- Joint diameter: 123 mm
- Total length: 544 mm
- ABS teeth: 45
- Diameter: 30 mm
- Height: 105 mm
- Hole spacing c/c: 241 mm
- Bearing thickness: 15 mm
- Diameter: 30 mm
- Height: 82 mm
- Hole spacing c/c: 241 mm
- Bearing thickness: 13 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,755 mm
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front left
- Flange diameter: 130 mm
- Total length: 613 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front left
- Flange diameter: 130 mm
- Total length: 565 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 648 mm
- Splines wheel side: 33
- Position: Front right
- Flange diameter: 130 mm
- Total length: 648 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 492 mm
- Splines wheel side: 38
- ABS teeth: 45
Frequently asked questions about Audi A6 Avant 2.8 Quattro
How do I know if my Audi A6 Avant 2.8 Quattro needs a new drive shaft?
Common symptoms include pronounced vibrations under acceleration or strange noises that persist even after replacing a CV joint. If the drive shaft is bent or has damaged splines, it should be replaced completely.
What is the difference between an inner and outer CV joint on a Quattro?
The outer CV joint is located at the wheel and accommodates steering angles, whereas the inner joint sits against the gearbox or differential and primarily absorbs axial movement as the suspension travels up and down.
Why is the ABS warning light on in my Audi A6?
On the Audi A6 Avant 2.8 Quattro, a cracked or heavily corroded ABS ring is a very common cause. This disrupts the signal to the sensor, causing the system to trigger a fault warning.
Can I replace just the CV joint instead of the entire drive shaft?
Yes, provided the shaft itself is straight and undamaged, you can simply replace the worn CV joint, which is often a more economical repair.
How does a worn propeller shaft affect driving?
A worn propeller shaft or a failing centre bearing typically causes vibrations felt throughout the entire bodyshell, particularly within specific speed ranges, and can also produce a distinct whining noise.
Is it difficult to find the correct parts for the 2.8 Quattro model?
No, simply select your car's make, model and engine variant in our search filter to bring up the exact parts tailored for the 2.8 Quattro specification, guaranteeing a correct fit.