Audi A6 Avant 3.2 FSI Quattro
Car parts and drivetrain components for Audi A6 Avant 3.2 FSI Quattro. Always check the fit before ordering.
Products for Audi A6 Avant 3.2 FSI Quattro
- Position: Front left
- Flange diameter: 123 mm
- Total length: 605 mm
- Splines wheel side: 38
- Position: Front left
- Total length: 617 mm
- Splines wheel side: 38
- Position: Front right
- Flange diameter: 123 mm
- Total length: 525 mm
- Splines wheel side: 38
- Position: Front right
- Flange diameter: 123 mm
- Total length: 655 mm
- Splines wheel side: 38
- Position: Outer
- Seal diameter: 59 mm
- Inner splines: 27
- Outer splines: 38
- Joint diameter: 100 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,763 mm
- Position: Rear left, Rear right
- Flange diameter: 108 mm
- Total length: 650 mm
- Splines wheel side: 38
- ABS teeth: 0
- Position: Inner
- ABS teeth: 0
- Inner splines: 28
- Joint diameter: 108 mm
- Outer diameter: 108 mm
- Position: Outer
- Inner splines: 33
- Outer diameter: 88 mm
- Splines wheel side: 38
Frequently Asked Questions about Drivetrain for Audi A6 Avant 3.2 FSI Quattro
How do I know if my Audi A6 Avant 3.2 FSI Quattro needs a new drive shaft?
The most common signs are heavy vibrations under acceleration or unusual noises from underneath the car. If the vibrations cease when you ease off the throttle, it is often an inner CV joint or the drive shaft itself that is worn.
Is there a difference in CV joints between Quattro and front-wheel-drive Audi A6 models?
Yes, Quattro models like the 3.2 FSI often feature different dimensions and spline counts to handle the torque distribution of four-wheel drive. Always select your make, model and engine variant to ensure the correct specification.
How often should I inspect the CV boots on my Audi?
We recommend a visual inspection at every service or seasonal tyre change. A split CV boot should be replaced straight away to prevent dirt and road grime from destroying the more expensive constant velocity joint.
Can I replace just the centre bearing, or does the entire propeller shaft need to be replaced?
On the Audi A6 Avant 3.2 FSI Quattro, it is often possible to replace only the centre bearing if the prop shaft is otherwise in good condition, offering a significantly more cost-effective solution.
What is included when I buy a CV joint kit from you?
Our kits are fully comprehensive and contain the CV joint, vehicle-specific CV boot, high-performance grease, circlips and all necessary clamps for a professional installation.
Do you provide a fitment guarantee on drivetrain parts?
Yes, when you choose your vehicle's make, model and engine on cvjoint24.com, your purchase is covered by our fitment guarantee, which means we guarantee the part will fit your specific Audi model.