Audi Q5 3.2 FSI Quattro
Car parts and drivetrain components for Audi Q5 3.2 FSI Quattro. Always check the fit before ordering.
Products for Audi Q5 3.2 FSI Quattro
- Position: Outer
- Seal diameter: 76 mm
- Inner splines: 27
- Outer splines: 42
- Joint diameter: 100 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,475 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,525 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,477 mm
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,645 mm
- Position: Front left, Front right
- Flange diameter: 123 mm
- Total length: 495 mm
- Splines wheel side: 42
- Position: Rear left, Rear right
- Diameter: 108 mm
- Flange diameter: 108 mm
- Total length: 660 mm
- Splines wheel side: 42
- Position: Rear
- Number of joints: 3
- Total length: 1,521 mm
- Position: Front, Outer
- Seal diameter: 76 mm
- Inner splines: 28
- Outer splines: 42
- Outer diameter: 94 mm
- Position: Outer
- Inner splines: 28
- Outer diameter: 99 mm
- Splines wheel side: 42
- Position: Front, Inner
- Total length: 84 mm
- Splines wheel side: 24
- Position: Front, Inner
- Total length: 88 mm
- Splines gearbox side: 34
- ABS teeth: 34
Frequently Asked Questions about Drivetrain for Audi Q5 3.2 FSI Quattro
How do I know if my Audi Q5 3.2 FSI Quattro needs a new drive shaft?
The most common signs are vibrations under acceleration or unusual noises while driving. If you notice the car shaking or see visible damage to the CV boots, it is time to check the drive shaft.
What is the difference between an inner and outer CV joint on this model?
The outer CV joint sits closest to the wheel and typically causes clicking noises when turning if it is worn. The inner CV joint sits closest to the gearbox and usually causes vibrations through the entire car under load.
Why is my Audi Q5 vibrating under acceleration?
Vibrations during acceleration on an Audi Q5 3.2 FSI Quattro are often caused by wear in the inner CV joints or an imbalance in the propeller shaft. It is important to inspect these components to prevent damage to the gearbox.
Can I replace just the CV joint instead of the entire drive shaft?
Yes, if the shaft itself is undamaged, you can often replace just the inner or outer CV joint. This is a cost-effective way to restore drivetrain function.
How does a damaged propeller shaft affect the all-wheel drive?
The propeller shaft transfers power to the rear wheels. If it is damaged or has worn centre bearings, it can cause severe vibrations and, in the worst case, prevent the all-wheel-drive system from operating properly.
Do all Q5 drive shafts fit the 3.2 FSI Quattro?
No, drive shafts vary depending on the engine option and gearbox type. Always select your car's make, model and engine on cvjoint24.com to ensure you get the correct part for your specific 3.2 FSI Quattro.