Audi A4 Allroad 2.0 TDI Quattro

Spare parts and drivetrain components for Audi A4 Allroad 2.0 TDI Quattro. Verify fitment by selecting your make, model and engine before ordering.

Products for Audi A4 Allroad 2.0 TDI Quattro

30 products
1 - 24 of 30
Item no.:0535320
  • Position: Outer
  • Seal diameter: 76,5 mm
  • Inner splines: 25
  • Outer splines: 42
Item no.:353589
  • Position: Front, Outer
  • Inner splines: 28
  • Outer diameter: 94 mm
  • Splines wheel side: 42
Item no.:0406013
  • Position: Inner
  • Inner splines: 24
Item no.:3103795
  • Position: Front left, Front right
  • Flange diameter: 123 mm
  • Total length: 469 mm
  • Splines wheel side: 42
Item no.:6181991
  • Position: Rear left, Rear right
  • Flange diameter: 100 mm
  • Total length: 626 mm
  • Splines wheel side: 42
Item no.:6201205
  • Position: Rear
  • Number of centre bearings: 1
  • Number of joints: 2
  • Total length: 1,630 mm
Item no.:4109241
  • Position: Rear left
  • Total length: 587 mm
  • Splines wheel side: 42
Item no.:5104467
  • Position: Rear right
  • Total length: 545 mm
  • Splines wheel side: 42
Item no.:0271924
  • Number of centre bearings: 1
  • Number of joints: 2
  • Total length: 1,529 mm
Item no.:6291775
  • Position: Rear
  • Number of centre bearings: 1
  • Number of joints: 3
  • Total length: 1,640 mm
Item no.:624961
  • Position: Rear
  • Total length: 1,675 mm
Item no.:6141096
  • Position: Rear left, Rear right
  • Flange diameter: 100 mm
  • Total length: 630 mm
  • Splines wheel side: 42
Item no.:0508598
  • Position: Outer
  • Seal diameter: 76,5 mm
  • Inner splines: 33
  • Outer splines: 42
  • Joint diameter: 88 mm
Item no.:0670443
  • Height: 85 mm
  • Inner diameter: 22 mm
  • Outer diameter: 80 mm
Item no.:3590538
  • Position: Front, Outer
  • Inner splines: 25
  • Outer diameter: 85 mm
  • Splines wheel side: 42
Item no.:0842131
  • Diameter: 30 mm
  • Height: 102 mm
  • Hole spacing c/c: 228 mm
  • Inner diameter: 30 mm
  • Bearing thickness: 15 mm
Item no.:620851
  • Total length: 1,646 mm
Item no.:358081
  • Position: Front, Outer
  • Inner splines: 28
  • Outer diameter: 94 mm
  • Splines wheel side: 42
Item no.:0427390
  • Position: Inner
  • Inner splines: 34
  • Outer splines: 123
Item no.:3184155
  • Position: Front left, Front right
  • Flange diameter: 123 mm
  • Total length: 466 mm
  • Splines wheel side: 42
Item no.:149840
  • Position: Front, Inner
  • Total length: 88 mm
  • Splines gearbox side: 34
  • ABS teeth: 34
Showing 1–24 of 30 products

Drivetrain for Audi A4 Allroad 2.0 TDI Quattro

Owning an Audi A4 Allroad 2.0 TDI Quattro means driving a vehicle engineered for both refined comfort and dependable capability in demanding conditions. The drivetrain is the core of this setup, transferring power from the efficient 2.0 TDI engine to all four wheels. To maintain the distinct driving feel and safety offered by the Quattro system, every driveline component must function flawlessly. Wear in the drivetrain can not only impair performance, but also lead to expensive consequential damage if ignored.

At CVJoint24, you will find a carefully curated range of components tailored specifically for the Audi A4 Allroad 2.0 TDI Quattro. We focus on providing parts that meet or exceed original equipment specifications. This is particularly vital for Allroad models, which regularly encounter tougher conditions than ordinary passenger cars. By selecting the correct components, you ensure your four-wheel-drive system continues to deliver maximum traction and stability on any road surface.

How the drivetrain is configured on the Audi A4 Allroad 2.0 TDI Quattro

The drivetrain on an Audi A4 Allroad 2.0 TDI Quattro combines mechanical precision with advanced engineering. Power originates at the engine and travels through the gearbox to a central differential, which distributes torque between the front and rear axles. A central propeller shaft runs along the underside of the car to drive the rear wheels, whilst front drive shafts deliver torque to the front wheels. Each drive shaft is fitted with both an inner and an outer CV joint to accommodate suspension travel and steering movements while maintaining smooth, continuous power delivery.

Because the Allroad sits higher off the ground than the standard Audi A4 Allroad model, the CV joints operate at slightly different working angles. This places high demands on material quality and lubrication. Constant velocity joints are protected by CV boots that retain grease and seal out contaminants. If a boot splits, the precision bearings inside the joint are quickly exposed to water and road grit, accelerating wear. Understanding this arrangement helps you quickly identify where potential issues may arise.

Common faults and symptoms

Several clear signs indicate that drivetrain components on your Audi A4 Allroad 2.0 TDI Quattro are wearing out. One of the most typical symptoms of a worn outer CV joint is a rhythmic clicking noise heard when turning sharply at low speeds. If you experience a shudder or vibration through the chassis under acceleration, a worn inner CV joint is frequently the cause. Vibrations can also occur if the prop shaft has lost its balance or its centre bearing has deteriorated.

Another frequent issue is grease leaking from a damaged CV joint boot. Grease splattered inside the wheel rim or wheel arch points directly to a split boot. If caught early, fitting a replacement boot kit with fresh grease may save the joint, but road dirt often penetrates quickly and damages the bearing surfaces. On Quattro models, it is also important to listen out for whining or humming noises from the differential or prop shaft, which can signal more extensive driveline wear that requires prompt attention.

Common replacement parts for Audi A4 Allroad 2.0 TDI Quattro

In our range for the Audi A4 Allroad 2.0 TDI Quattro, we stock the vital driveline parts most commonly replaced during the car's service life. We currently stock 16 high-quality parts for this specific model variant. Among these are 9 different drive shafts, covering front and rear axle requirements. Replacing a complete driveshaft is often the most cost-effective repair, as you receive brand-new inner and outer joints fully assembled and ready to fit.

If you only need individual components, we also supply 2 types of outer CV joints and 2 types of inner CV joints. In addition, we offer 3 different propeller shafts, essential for keeping your Quattro all-wheel-drive system working as intended. Selecting the right part from the start prevents future driveline trouble and keeps your vehicle running smoothly. All our car parts are thoroughly tested to withstand the demanding torque output of the TDI engine.

How to find the right part for your Audi A4 Allroad 2.0 TDI Quattro

Navigate directly to the appropriate section for the Audi A4 Allroad 2.0 TDI Quattro:

When diagnosing drivetrain faults, starting in the precise product category saves valuable time. By comparing the dedicated component groups for the Audi A4 Allroad 2.0 TDI Quattro, it is straightforward to distinguish between drive shaft, CV joint, or prop shaft issues and choose the correct replacement for your symptoms.

These links take you straight to verified spare parts for your model variant. If you require further assistance, our technical specialists are always on hand to help you choose the correct components.

Why buy from CVJoint24?

CVJoint24 is the international shop of a Swedish driveline specialist, dispatching directly from our central warehouse in Helsingborg, Sweden, to customers across the European Union. We have an enduring passion for power transmission and a deep technical understanding of the vehicles we cater for. When you order from us, you gain access to genuine expertise and the confidence that comes with fitting quality components. Simply select your car's make, model, and engine variant to ensure an accurate fit every time.

We know that vehicle repairs are time-sensitive, which is why we prioritise prompt dispatch to keep your car's downtime to a minimum. Combining strict quality standards, specialist advice, and competitive pricing, we ensure you receive reliable parts backed by real knowledge. Whether you are a professional workshop mechanic or an enthusiastic DIYer, you can count on CVJoint24 as your trusted partner for Audi A4 Allroad 2.0 TDI Quattro drivetrain components.

Frequently asked questions about Drivetrain for Audi A4 Allroad 2.0 TDI Quattro

How do I know if my Audi A4 Allroad 2.0 TDI Quattro needs a new drive shaft?

The most common signs are vibrations under acceleration, clicking noises when cornering or visible damage to the CV boots. If you notice grease splattered inside the wheel rim, you should inspect the shaft immediately.

What is the difference between the inner and outer CV joint on this model?

The outer CV joint is located closest to the wheel and accommodates steering angles; when worn, it typically produces a clicking sound. The inner CV joint sits closest to the gearbox and primarily absorbs suspension movement; wear here usually causes vibrations throughout the car.

Do all drive shafts from the standard Audi A4 also fit the Allroad model?

No, the Allroad features a unique chassis setup and raised ground clearance, which can mean differences in driveshaft lengths and operating angles. Always select your specific make, model and engine to ensure the correct fitment.

Why is it important to replace a vibrating propeller shaft?

An unbalanced propeller shaft can cause severe damage to the gearbox output shaft, the differential and the centre bearing. Prolonged vibrations can lead to extensive and costly repairs across the entire Quattro system.

Do you offer a fitment guarantee on drivetrain parts for Audi?

Yes, when you select your specific vehicle details on cvjoint24.com, your purchase is covered by our fitment guarantee, ensuring the part fits your Audi A4 Allroad 2.0 TDI Quattro correctly.

How quickly can I receive my spare parts?

We process all orders promptly to get your car back on the road as quickly as possible, shipping fast and reliably across the European Union.