Audi A6 Avant 1.8 T Quattro
Car parts and drivetrain components for Audi A6 Avant 1.8 T Quattro. Always check the fit before ordering.
Products for Audi A6 Avant 1.8 T Quattro
- Diameter: 30 mm
- Height: 105 mm
- Hole spacing c/c: 241 mm
- Bearing thickness: 15 mm
- Diameter: 30 mm
- Height: 82 mm
- Hole spacing c/c: 241 mm
- Bearing thickness: 13 mm
- Position: Inner
- Seal diameter: 100 mm
- Inner splines: 33
- Joint diameter: 100 mm
- Position: Outer
- ABS teeth: 45
- Seal diameter: 53 mm
- Inner splines: 30
- Outer splines: 33
- Position: Rear
- Number of centre bearings: 1
- Number of joints: 3
- Total length: 1,755 mm
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front left, Front right
- Flange diameter: 123 mm
- Joint diameter: 123 mm
- Total length: 544 mm
- ABS teeth: 45
- Position: Outer
- ABS teeth: 45
- Seal diameter: 59 mm
- Inner splines: 33
- Outer splines: 38
- Position: Front
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
- Position: Front left
- Flange diameter: 130 mm
- Total length: 625 mm
- Splines wheel side: 38
- ABS teeth: 45
- Position: Front right
- Flange diameter: 130 mm
- Total length: 643 mm
- Splines wheel side: 38
- ABS teeth: 45
- Total length: 661 mm
- Splines wheel side: 38
- ABS teeth: 45
- Total length: 653 mm
- Splines wheel side: 38
- ABS teeth: 45
- ABS teeth: 45
- Inner diameter: 77 mm
- Outer diameter: 81 mm
- Width: 11 mm
Frequently Asked Questions about the Drivetrain for Audi A6 Avant 1.8 T Quattro
How do I know whether it is the inner or outer CV joint that has failed on my Audi A6 Quattro?
A worn outer CV joint usually produces a clicking noise when cornering sharply, whereas a faulty inner CV joint tends to cause vibrations through the entire vehicle during acceleration. On a Quattro model, vibrations can also originate from the propeller shaft, so be sure to check both.
Does the same drive shaft fit both the right and left side on the Audi A6 Avant 1.8 T Quattro?
This varies depending on the model year and gearbox. Always select your specific make, model and engine configuration to confirm the exact fitment for your vehicle.
Why is it important to replace a cracked ABS ring?
A cracked ABS ring sends faulty signals to the vehicle control unit, which can cause the ABS system to pulse during normal braking or trigger the warning light, resulting in an MOT or roadworthiness inspection failure.
Do your CV joint kits include everything needed for the replacement?
Yes, our CV joint kits come complete with a CV boot, grease, clamps and fitting accessories, allowing you to carry out the repair immediately without having to source extra parts.
How does the Quattro system affect drivetrain wear?
Because Quattro provides permanent all-wheel drive, engine power is continuously distributed across all four drive shafts and the propeller shaft. This provides superior traction, but it also means more components are subjected to mechanical wear compared to a two-wheel-drive car.
Can I replace just the centre bearing on my Audi A6 propeller shaft?
In some instances, the prop shaft design allows the centre bearing to be replaced separately; however, it is often more cost-effective and reliable to replace the complete shaft if it has begun to vibrate, ensuring proper balance throughout.